Win7 system computer every time always press F2 to enter the system how to do

Win7 System computer every time always press F2 to enter the system how to do? Win7 System encountered a boot failure problem is one of the common problems, I believe many users have encountered, such as Win7 system computer every time to press F2 to enter the system, how to do? cause Win7 system computer every time to press F2 to enter the system is a number of reasons, The following small series tells everyone three kinds of solutions.

Workaround One:

1, the computer does not install floppy drive or floppy disk failure, and in the BIOS is set up with a floppy drive, this situation will lead to F2 prompts;

2, in most cases, only need to restore the BIOS default settings to return to normal;

3, some of the older motherboard defaults will also open the floppy drive, when entering the BIOS, please select the first "Standard CMOS Features";

4, after entering the "Drive A" set to "None", "Floppy 3 Mode Support" set to "Disable";

5, return to the BIOS settings main interface, select "Advanced bios Features" settings, press ENTER enter;

6, "Boot up floppy Seek" set to "Disabled";

7, press F10 Save, ESC key to exit the BIOS settings, restart the computer can be.

Workaround Two:

1, the motherboard has a button battery to maintain the computer without power connected to save the BIOS settings and continue the motherboard clock operation, if the button battery is not electricity will cause this situation. At this point, the first need to disconnect the computer host power cord, open the computer chassis;

2, to find the button on the motherboard battery;

3. Use a screwdriver to pry the battery down;

4, reinstall a new CR2032 battery;

5, close the chassis, connect the power cord, start the computer. Press the DEL key to enter the BIOS settings, restore the computer default settings;

6, save the settings and exit the BIOS, restart the computer.

Workaround Three:

1, if the computer has two hard drives or more than one hard drive, or optical drive, when directly from the computer unplugged hard disk or optical drive uninstall, the BIOS settings are not updated;

2, now the computer motherboards generally have hard disk drive automatic detection function, into the BIOS settings, select "Standard CMOS Features";

3, the hard drive and optical drive are set to automatic detection can be.

The above tutorial content is win7 system computer every time to press F2 to enter the system solution, have encountered the same problem users, can refer to the above tutorial to solve.