Win7 system How to set IPV6 protocol address

Win7 System How to set IPV6 protocol address

The method is as follows:

1, the installation of IPV6 protocol: Open the Control Panel, and then into the "Network and the Internet"-"network Connection"-Right click "Local Connection", in the Pop-up Properties dialog box click on the installation, and then select "Protocol", click Add, you can install IPV6 to the project list. After the installation is complete, the following illustration shows:

2, set IPV6 address: Open the Control Panel, and then into the "Network and the Internet"-"network Connection"-Right click "Local Connection", in the pop-up Properties dialog box, double-click Internet Protocol version 6 (TCP/IP), in its property box, select Manual, enter IPV6 address " 3ffe:ffff:7654:feda:1245:ba98:3210:4562 "(Since the IPV6 is in the test phase, it is free to enter and determine its address).

3, Test IPV6 settings: Press "Win+r" to open the Run dialog box. Enter cmd and enter the "ipconfig" command in the pop-up msdos window to view all local IP address configurations.

4, the configuration ISATAP tunnel, completes, opens the browser, enters the website "http://ipv6.jmu.edu.cn/" carries on the IPV6 test, on the page, if can see a dancing small tiger, then shows you to IPV6 to visit this webpage, if the tiger does not dance, You are accessing the Web page in IPV4.

Windows7 Tutorial

WINDOWS8 Tutorial

WINDOWS10 Tutorial