WIN8 installation driver display data Invalid how to do

WIN8 installation driver display data Invalid how to do

1, first press the combination of key Win+r open the Run window, enter services.msc and press ENTER, as shown in the picture:

2. Call the service window and find the device Install service and device Setup Manager in the list on the left side of the service window, and make sure both services have been started

Note: Alternatively, you can run the command prompt directly as an administrator, and then execute the following two commands:

net start Deviceinstall

net start Dsmsvc

As shown in the figure:

Note: Apple mobile Device Support, the driver for the MAC device, will cause the installation to fail if the above two service entries are not turned on, and the "Smart card" service will be used to properly identify and use the network Silver Shield when installing Bank Shield drive. The net silver of other banks should be the same.