WIN8/7 System WLAN Wireless service "WLAN AutoConfig" cannot be opened what to do

The error status is as follows

The wireless network does not display correctly or the Red fork, and then we click on the WLAN AutoConfig prompts not to start, as shown in the following figure

cause Analysis

This problem may occur because after optimizing the software optimization system, we can fix it together.

I. Solutions (found on the internet that can be solved by using the registry)

1, run regedit, open Hkey_local_machine/system/currentcontrolset/services/ndisuio, view its displayname is NDIS usermode I/O Protocol. Change the value of the Strat to 2.

2. Start-run-cmd-enter netsh winsock reset carriage return

Restart the computer

Friendly Tips

Note:
Netsh is an interface that can operate almost all network-related settings through the command line, such as setting up IP, DNS, network cards, wireless networks, and so on.
Winsock is the system internal directory, Winsock is the Windows Network programming interface, Winsock work in the application layer, it provides the low-level transport protocol independent of the high-level data transfer programming interface.
Reset is the reset operation on the Winsock.
netsh winsock reset command, which is to reset the Winsock directory. If there is a problem with the Winsock protocol configuration on one machine, it will cause the network connection and so on, you need to reset the Winsock directory with the Netsh winsock reset command to restore the network. This command can reinitialize the network environment to resolve the problem of parameter errors due to software conflicts and virus causes. After the execution of the Winsock command restart the computer, you need to reconfigure the IP, of course, automatically assign IP restart direct use can be.