Windows cannot automatically bind the IP protocol stack to a network adapter solution

The lab's desktop is not on the network after the upgrade drive, the cable network card driver uninstalled after the reload, or not, through Windows diagnostics found that "Windows cannot automatically bind the IP protocol stack to the network adapter solution."

Workaround:

Open Control Panel >> Network and Internet >> Network Connections, right-click the network you want to view, select Properties,

Uncheck "Network Lightweight Filter" and click "OK" to instantly connect to the Internet.

More references to Chief handyman notes

Specific as follows:

All say life is a toss , but to a certain age, but do not want to do those meaningless toss.

A few times a year to toss, every time there are tricks ...

Due to hand owed, a driver was updated, resulting in a notebook not being able to surf the Internet under Windows 7. There are a number of ways to try it, including uninstalling, reloading, updating drivers, and using Boot Camp to re-create the driver installation tools that Apple provides for Windows systems. Then, using the Windows-brought diagnostic tool as a diagnostic, the system gives the hint that Windows cannot automatically bind the IP protocol stack to a network adapter. According to this keyword, found the method. The situation I encountered was slightly different.

Open Control Panel >> Network and Internet >> Network Connections, right click on the network you want to view, select "Status", and 无线网络连接 状态 Click "Properties" in the interface to see the details.

Only select "Microsoft network Client", "QoS Packet Scheduler", "IPv6" and two "link layers ...".

If not unexpectedly, this time should be able to surf the internet normally.

We can check the other options to get rid of the problem.

The problem I encountered here is Network LightWeight Filter that the Internet is a check to know that it is I installed "Xiaomi portable Wifi" in passing installation. Usually used very little, unexpectedly such a toss, it is because of its reasons. Here remind you, if you do not use this kind of service, you can try to uninstall or disable the relevant driver, so as not to cause unnecessary trouble.

After re-taking the "Xiaomi Wifi" into the computer and reloading the corresponding software, then tick "network lightweight Filter", the internet is also normal, you can also create a new Wi-Fi network.

To this point, the "Windows cannot automatically bind the IP protocol stack to the network adapter" problem is resolved.

Method Summary:

If you encounter a similar problem, use the tools that came with your system to analyze the cause and then target the search to find a solution to the problem more efficiently.

2015-3-22 1:02:07

Windows cannot automatically bind the IP protocol stack to a network adapter solution