Windows under NC file transfer

First Use the command:

Receiving end: nc–n–l–p port–vv > XXX

Send side: Nc–n IP Port < yyy

But found that after the data transfer is complete, will not automatically disconnect, to manually disconnect, here is also prone to error because you do not know the transmission is complete no, very bad.

Looked at help, found the following parameters:

The following commands are used for the modification:

Receiving end: Nc–n–l–p port–vv–w 3 > XXX

Send side: Nc–n IP Port < yyy

Smooth file transfer

Of course, you can also use:

Receive end: NC–N IP Port > yyy

Send side: nc–n–l–p port–vv–w 3 < XXX

Windows under NC file transfer