1, open the WPS software, the following figure.
2, in the above menu bar to find the insert, and then follow the arrows to find the Insert header footer. Click.
3, the following figure, in the position of the header and footer there is a blinking cursor, in the header out of everyone can enter content, so the entire article header is the same.
4, slide the mouse to the following, click on the Insert Page number, and then select the bottom center, apply to the entire article. This is the same method if you have an existing article to change the page number.
5, click OK, the following figure, you will see the page number, the whole article on the sorting success.
As shown below, click "Modify page Number" to set the application range to "page and later", the following starting value is set to "1", OK. When you're sure, WPS will automatically set this page and later into a new section, just as you would set a separate page number effect by inserting a section break directly in chapter management.