Configuring Netdump Servers and clients

Netdump requires at least one server and any number of clients.

Server configuration:

1. Verify that the Netdump server is installed:

Rpm-q Netdump-server

If it is not installed, execute the command:

Up2date Netdump-server

For installation.

2. After the server package is installed, use the command:

passwd Netdump

Change the user's password.

3. Open the server:

Chkconfig Netdump-server on

4. Running the server:

Service Netdump-server Start

Client Configuration:

1. Verify that the client is installed:

Rpm-q Netdump

If the Execute command is not installed:

Up2date Netdump

Installation.

2. Edit the file/etc/sysconfig/netdump and add the following line:

netdumpaddr=192.168.0.5

&http://www.aliyun.com/zixun/aggregation/37954.html ">NBSP; *
o 192.168.0.5 refers to the server address.

3. Enter the following command and password when the prompt appears:

Service Netdump Propagate

4. Open the client:

Chkconfig Netdump on

5. Run the client:

Service Netdump Start

All incoming SYSRQ commands are sent over the network to the Netdump server and stored in the/var/crash directory. The Netdump file name produced by the default is Vmcore.