Using Fedora Linux To configure RAID requires careful follow some steps. In the example of this tutorial, you will use a system to configure RAID5, whose hard disk is divided into three areas in advance. The partitions used are as follows:
/dev/hde1/dev/hdf2/dev/hdg1
Please make sure that the steps listed below will suit your particular environment.
RAID partitions
First, you have to delimit two or more partitions, each on a separate disk. If you build RAID 0 or RAID 5, each partition should be roughly equal, just like this scenario. RAID limit data has less access to each partition than the smallest partition in the RAID set
Determining Available partitions
First, use the fdisk-l command to view all available, mounted, or not mounted file systems on your system. You may also want to use the DF command to display mount points for installed file systems.
These two commands will help you easily delineate the partitions you want to use. The following is an example of some output information for these two commands.
The content source of this page is from Internet, which doesn't represent Alibaba Cloud's opinion;
products and services mentioned on that page don't have any relationship with Alibaba Cloud. If the
content of the page makes you feel confusing, please write us an email, we will handle the problem
within 5 days after receiving your email.
If you find any instances of plagiarism from the community, please send an email to:
info-contact@alibabacloud.com
and provide relevant evidence. A staff member will contact you within 5 working days.