Guide to using the Dwarf DOS Toolbox

How to use the Dwarf DOS toolbox

1 after the completion of the installation of all the above backup work and the above need to note the details please check the above mentioned a use of ghost before you must pay attention to the things please carefully check

2 Make sure that all of your important files in C are backed up to other disks. Make sure you have enough disk space for your mirrored files (at least a large amount of all of the used file space in C disk) determine that you already know your disk File system format is FAT32 or NTFS determines that you are ready to do so

3 Restart the computer

4 The two system boot options appear on top of your screen before you go into the system

One for Windows XP normal boot Two for the following my DOS toolbox

5 Choose to enter my DOS Toolbox will have a Chinese menu selection, mainly the first two,

1 Dwarf Studio DOS tool disk 2GHOST 8.2 Wizard Tool Tray

Here are all Chinese operating interfaces you should say you can understand this. Select the Ghost 8.2 Wizard Tool Tray

6 Ghost When the tool disk is entered, there are several options as shown below

Backup operations

1 One-click Backup system supports NTFS (select this if your file system is NTFS formatted)

3 Automatic backup system FAT32 only (Select this if your file system is FAT32 format)

After the selection will have a Chinese hint as shown

This is usually the first hard drive you can install dual hard drive backup to a second hard drive if necessary

The next operating interface appears when you select the first hard drive.

This means that your system disk will be made as a mirrored file

The file name is bak.gho default is stored in D disk directory you can go to Windows to find this file

Do not move this file or folder