Red Flag Linux Desktop 6.0 user manual: Setting Scim Input Method

SCIM built-in an excellent setup program for users to facilitate the customization of input method.

The Settings dialog box pops up when the user right-clicks the Scim Input Method toolbar.

shortcut menu

6.2.1 Input method and code table settings

The main interface of the Input Method Settings window is shown in the following illustration.

Input Method Settings window main interface

SCIM default is to open all the available input method, but the appropriate deletion of the use of low usage of input method in addition to improve the user to select the speed of input method, but also reduce the consumption of system resources.

For code table Management operations, you need to be in the "input engine" in the "Global Configuration", where the user can select or cancel the Input method before the check box to add or subtract input method.

Global configuration

In the General tab of the Common Code table, the user can set the properties of the candidate box for the Word table, and can do the higher priority of the user-defined words.

General Code Table General Options

In the Universal Code table, you can also set the shortcut keys for the input method, click the Keyboard tab, and enter the shortcut key setting interface as shown in the following figure.

Universal Code table Keyboard options

Here, the user can modify the full/half angle switch, the input mode, add and remove the word shortcut keys to change settings.