Windows Server 2003 dual-node cluster installation Guide

During installation, other nodes are closed when certain nodes are installed. This step helps ensure that data on disks attached to the shared bus is not lost or compromised. Data loss or damage can occur when multiple nodes try to write to a disk that is not protected by the cluster software at the same time. Unlike the http://www.aliyun.com/zixun/aggregation/11208.html ">microsoft Windows 2000 system, Windows 2003 Server The default mount mode for new disks in is changed. In Windows 2003, the system does not automatically mount logical disks that are not on the same bus as the boot partition, nor do they have a drive letter assigned to them. This helps ensure that the server does not load drives that might belong to another server in a complex SAN environment. Although the server does not automatically mount the drive, it is still recommended that you follow these steps to ensure that the shared disk is not compromised.

Use the following table to determine which nodes and storage devices must be shut down at each step.

The steps in this guide apply to a two-node cluster. If you are installing a cluster with more than two nodes, the Node 2 column lists the required states for all other nodes.

Before you configure the Cluster service software, you must perform several steps. These steps are:

Install the Windows Server 2003 Enterprise Edition or the Windows Server 2003 Datacenter Edition operating system on each node.

Set up a network.

Set up the disk.

Before you start installing the Cluster service on the first node, you must perform these steps on each cluster node first.

To configure the Cluster service, you must be logged on with an account that has administrative permissions on all nodes. Each node must be a member of the same domain. If you choose to use one of these nodes as a domain controller, you should set up a domain controller on the same subnet to eliminate the single point of failure and maintain the node.