ZTE interprets hammer aging test: Use only 10 times a day for three years

Absrtact: ZTE published a report entitled "Rough solutions to the aging test report of Hammer T1 mobile phone", which was interpreted by the Hammer technology founder Luo's "Smartisan T1 accelerated Aging Test Report" September 5. ZTE said in its report that GB and yd standards stipulate

ZTE published a report entitled "Rough solutions to the aging test report on Hammer T1 mobile Phones", which was interpreted by the Hammer technology founder Luo's "Smartisan T1 accelerated Aging Test Report" released September 5.

ZTE said in the report, GB and yd standard power supply keys and side keys for 50,000 times, T1 report is 15,000 times, if it is used three years, only 10 times a day.

ZTE also said that in the chemical test, the general manufacturers are using alcohol or cosmetics, in the 35-45-degree environment for 24 hours, and the hammer phone is only kept in room temperature for an hour.

September 5, Luo released from the Foxconn Langfang Laboratory "Smartisan T1 accelerated Aging Test Brief", the purpose may be to prove the quality of hammer phone is good, but after the rough solution of ZTE, the result is ... So far, Luo and hammer technology have not responded to ZTE's report.

The following is "hammer T1 mobile phone aging test Report Rough Solution" original:

Because the standard text is in the office, some parameters are not clear, only rough solution.

First, the standard basis, the test report statement is based on Motorola laboratory standards, so it can not be GB or yd standards, just with GB, yd standard contrast analysis.

Second, the fall standard. The report describes the use of PVC drop surface, PVC is what I do not explain, GB and yd standards and most operators are used by manufacturers of marble, concrete, steel, who the hardness, we will know. The key Four corners of the drop angle did not fall, this is also the king freely points out that the design defects, fall behind the screen will be from the corner crack.

Three, the button life, GB and yd standard power supply keys and side keys for 50,000 times, T1 report is 15,000 times, that is, the use of one year, 40 times a day, according to three years use, only 10 times a day, to use three years of classmate, you ready to countdown?

Four, squeeze test, standard requirements 250N,T1 report is 35 pounds force, equivalent to 155N. Classmate, do not put in the trouser pocket, careful pressure to.

Five, vibration test, standard requirements 10-500hz, 30 minutes per surface, vibration parameters are acceleration or power spectral density. The T1 report is 30HZ, with a total of 30 points in six faces, replacing the acceleration or power spectra with displacement parameters.

Six, chemical testing, the general manufacturers are using alcohol or cosmetics, in the 35-45-degree environment to save 24 hours. The T1 report is only kept for an hour at room temperature.

Seven, temperature test, T1 high temperature and humidity temperature index of 45 degrees higher than the standard, but the humidity and test time than the standard is much lower. Hot and cold impact test temperature conversion speed is generally 15 seconds, T1 10 minutes to the impact of a discount.