Default Gateway Static Ip

Your server needs to have a single default gateway. A network adapter configured with DHCP automatically assigns a default gateway to the DHCP server, but a network adapter configured with a static IP address needs to manually configure the default gateway. This can be done with a simple command. In this example, the default route uses a newly installed http://www.aliyun.com/zixun/aggregation/32544.html "> wireless network card wlan0, and most PCs use standard Ethernet card eth0. ...

Intermediary transaction http://www.aliyun.com/zixun/aggregation/6858.html ">seo diagnose Taobao guest cloud host technology Hall dual-line dual-IP is very good, netcom users to visit the Netcom line, telecommunications users access to telecommunications lines. 　　Many people will choose to import static routing table, this approach seems perfect, in fact, a lot of problems. 1, telecommunications users should be resolved to Netcom's IP, the server according to the routing table will return to the telecommunications line, but the user request is ...

One of the features of cloud computing is the ability to move applications from one processor environment to another. This feature requires a target operating system to receive it before moving the application. Wouldn't it be nice if you could automate the installation of a new operating system? A well-known feature of the intel™ architecture system is the ability to install Linux automatically. However, installing Linux automatically is a tricky issue for System P or IBM power BAE using the hardware management console. This article discusses the solution of ...

In this article, you can learn how to configure a Fortinet Security Fabric that consists of four FortiGate devices and a FortiAnalyzer.

This article describes how to set up a large number of spoke VPNs by using quick mode selector source definitions on the spoke FortiGates and the dialup VPN configurations on the hub FortiGates.

This article shows how to setup an active-passive session-aware load balancing cluster (SLBC) consisting of two FortiGate-5000 chassis, four FortiController-5103Bs two in each chassis, and six FortiGate-5001Bs acting as workers, three in each chassis.

1. Network configuration (1) command configuration # ifconfig eth0 192.168.0.2 netmask 255.255.255.0//ip address, Subnet mask # route add default GW 192.168.0.1 dev eth0//Gateway # HO Sthttp://www.aliyun.com/zixun/aggregation/11696.html ">n ...

This recipe provides an example of how to set up a FortiGate for redundant Internet connectivity using SD-WAN and then convert this single FortiGate into an FGCP HA cluster of two FortiGates.

In this example, you connect and configure a new FortiGate in NAT mode in FortiOS 6.0, to securely connect a private network to the Internet.

In this example, you will learn how to connect and configure a new FortiGate unit in NAT/Route mode to securely connect a private network to the Internet.