Device Hostname

This article shows how to setup an active-passive session-aware load balancing cluster (SLBC) consisting of two FortiGate-5000 chassis, four FortiController-5103Bs two in each chassis, and six FortiGate-5001Bs acting as workers, three in each chassis.

In this recipe you set up a FortiGate Clustering Protocol (FGCP) virtual clustering configuration with four FortiGates to provide redundancy and failover protection for two networks.

Refer to Hadoop_hdfs system dual-machine hot standby scheme. PDF, after the test has been added to the two-machine hot backup scheme for Hadoopnamenode 1, foreword currently hadoop-0.20.2 does not provide a backup of name node, just provides a secondary node, although it is somewhat able to guarantee a backup of name node, when the machine where name node resides ...

One of the features of cloud computing is the ability to move applications from one processor environment to another. This feature requires a target operating system to receive it before moving the application. Wouldn't it be nice if you could automate the installation of a new operating system? A well-known feature of the intel™ architecture system is the ability to install Linux automatically. However, installing Linux automatically is a tricky issue for System P or IBM power BAE using the hardware management console. This article discusses the solution of ...

When we use putty, SECURECRT, or other terminals to log on to Linux, how do we know the path and host name after landing? Examples are as follows: [Root@localhost ~]# pwd/root [root@localhost ~]# hosthttp://www.aliyun.com/zixun/aggregation/11696.html] > Name Localhost.loca ...

In this recipe you set up a FortiGate Clustering Protocol (FGCP) virtual clustering configuration with two FortiGates to provide redundancy and failover protection for two networks.

This recipe describes how to enhance the reliability of a network protected by a FortiGate by adding a second FortiGate and setting up a FortiGate Clustering Protocol (FGCP) High Availability cluster.

This recipe provides an example of how to set up a FortiGate for redundant Internet connectivity using SD-WAN and then convert this single FortiGate into an FGCP HA cluster of two FortiGates.

This article shows how to setup an active-passive session-aware load balancing cluster (SLBC) consisting of two FortiGate-5000 chassis, four FortiController-5103Bs two in each chassis, and six FortiGate-5001Bs acting as workers, three in each chassis.

1. Network configuration (1) command configuration # ifconfig eth0 192.168.0.2 netmask 255.255.255.0//ip address, Subnet mask # route add default GW 192.168.0.1 dev eth0//Gateway # HO Sthttp://www.aliyun.com/zixun/aggregation/11696.html ">n ...