Centos 5 系統安裝

標籤：

[1]	Insert an installation DVD and restart Computer. Next, the following screen is shown, then Push Enter key.

[2]	This is the section to check the installation DVD, Select to check or skip to proceed next.

[3]	Click "Next" button to proceed.

[4]	Select the language you‘d like to use during the installation.

[5]	Select the keyboard type you using.

[6]	Click ‘Yes‘ and proceed to next if it‘s no ploblem that all existing data on HD are lost.

[7]	Change partition layouts. Click the checkbox ‘Reviw and modify partitioning layout‘ and proceed next.

[8]	Click ‘Yes‘ if it‘s OK.

[9]	This is the section for changing partition layouts. This example shows to configure LVM partition layouts (Set /boot, /. swap, /home on here) . First, select "/" and Click "Edit" button.

[10]	Focus on / and click "Edit" button.

[11]	Reduce the volume size for "/" to make free areas.

[12]	Click "Add" button and input mount point, logical volume‘s name, size for /home.

[13]	Click "Next" button if it‘s OK all.

[14]	This is the bootloader section. Set configuration for boot loader if you need.

[15]	It‘s the section to configure for networking. Click ‘Edit‘ button to set config.

[16]	Uncheck the IPv6 if you don‘t need to it. DHCP is unneccessary for server usage, so select "Manual configuration" and input your server‘s IP address in IPv4 section like below.

[17]	Input your server‘s Hostname as [(any name you like).(domain name you got)]. And Input the Gateway‘s and nameserver‘s address for your local network like below.

[18]	Set your timezone and go next.

[19]	Set root password and go next.

[20]	This is the section you select softwares you would like to install. It‘s not recommended to install many softwares first. Check a box ‘Customize now‘ and go Next.

[21]	Unckeck boxes first and Check a box ‘Base‘ only and go Next.

[22]	Click ‘Next‘ to proceed.

[23]	Wait for a moment. Installing is just being done.

[24]	Installation has finished. Click the ‘Reboot‘ button.

[25]	The following screen is shown at initial booting. It‘s possible to configure about following sections. You can enter this configuration mode later with a command ‘setup‘ If you skip this steps now.

[26]	Booting CentOS has completed and login prompt is shown. Input ‘root‘ as a username and push ‘Enter‘ key, and next, Input password for root which you set during the installation.

Centos 5 系統安裝