1tb ide hard drive

Q: I installed a couple of hard drives a few days ago I loaded two hard drives onto an IDE line, and the hard drive was not recognized. Later, the main disk and CD-ROM installed together, found the hard

First, capacity The size of the mobile hard disk capacity is the first choice for many people, usually in GB or TB units, the current market mainstream mobile hard disk capacity has 320GB, 500GB, 1TB, 2TB and so on. The size of the capacity is directly related to the user's storage needs, the choice of mobile hard dis

Factory is as the master disk, which is not required when only one hard drive is installed, but when multiple hard drives are installed, the hard drive jumper needs to be reset. The jumper on the hard disk is simpler, and the jum

temperature, the difference is also possible. Generally speaking, the motherboard, hard disk temperature is lower than the CPU, the motherboard is generally 40-60 degrees between the temperature is acceptable, hard disk temperature, the normal IDE or SATA hard disk temperature should be below 55 degrees is normal. Wh

BIOS setup hard drive mode, what does it mean to change the hard drive mode to IDE in BIOS? Our hard disk is divided into two kinds of interfaces, one is IDE, the other is SATA. Previo

The solution to the hard drive after computer boot: Just bought the computer boot ready to the hard disk partition install the operating system, but at this time, the problem arises, the machine to start self-test after the prompt can not find the hard disk In the beginning, I think it is the motherboard bios in the

Top 10 hard drive saving strategies In order to effectively save the data in the hard disk, in addition to regular backup work, we also need to learn how to save the hard disk when the hard disk fails, or extract useful data from the bad area, minimize the loss. I.

connected. 3. Try reconfiguring the "PNP/PCI configuration" "Reset Configuration Data" in the BIOS to be set to "Enabled" using the BIOS options such as "Force Update ESCD", and then save the disk exit. If you can not start, try to set the "Disabled" to try. 4. Check the motherboard manual for CMOS jumper information and clear the CMOS. Please note that when you clear the CMOS settings, you must unplug the host power cable or set the host power switch to off or 0. 5. Disconnect the

drive connector line instability, hard disk physical damage. Processing method: One, CMOS caused by the fault The correct type of hard disk in the CMOS (that is, the BIOS system) directly affects the normal use of the hard disk. Today's machines support the "IDE Auto Det

hard disk writing is not very stable, so the data of the test is very different. From the test, the Seagate's SATA3.0 2TB hard disk and SATA2.0 1TB hard disk in the file copy of similar results, can also be intuitive to see the advantages of SATA3.0 is not reflected. 　　Full Text summary In fact, from the PATA to the

In order to effectively save the data in the hard disk, in addition to regular backup work, we also need to learn how to save the hard disk when the hard disk fails, or extract useful data from the bad area, minimize the loss. Hard Disk not recognized by System The system cannot be started from the

In order to effectively save the data in the hard disk, in addition to regular backup work, we also need to learn how to save the hard disk when the hard disk fails, or extract useful data from the bad area, minimize the loss. I. Hard Disks are not recognized by the System The system cannot be started from the

would invest $4.3 billion in cash plus stock to acquire a Hitachi wholly owned subsidiary, Hitachi Global Storage Technology (HGST), a world-class hard drive manufacturer. Hard Disk Interface Ata Full name Advanced Technology attachment, is the traditional 40-pin with the port data cable to connect the motherboard and har