androidap

Step 1. Check that the connection method is correct 1. On the standby screen we first find the "app" and click Enter. 2. We first find "set" and then click Enter. 3. Slide the right side of the WLAN slider to the right to turn it green. 4. We first find the "WLAN" and click Enter. 5. A list of wireless APs on the screen showing the WLAN network. 6. Click on an AP device that you want to connect to, ta

Currently, it is faster to watch videos over a wired connection than to go through a vro and use wireless connection as a hotspot. However, after setting a hotspot in a wireless connection, you have to turn on the hotspot again after shutdown or restarting, Which is troublesome, it is more convenient to add a self-starting hot spot on startup. Other devices can access the Internet through the box even if the network speed is fast and the video is not card. Development Tools Android ADT Implem

Follow these steps: 1. In standby mode, click "Application". 2. Select "Set". 3. Select "WLAN" and slide the icon of the rectangle to the right to make it green. When the 4.WLAN is turned on, a wireless device can be found on the screen and click on the wireless device that needs to be connected. 5. Enter the connection password and click "Connect". If your phone is still not online after you turn on the WLAN, try the following: 1. Open wireless router wireless signal and ensure the

1. Click the application icon on the standby page.2. Click the set icon.3. Click Connect and enable WLAN.4. Click [WLAN ].5. Click a wireless hotspot (here "AndroidAP" is used as an example ).6. Select show advanced options.7. Slide down and change the IP address setting to static ].8. Enter the IP address and Gateway parameters based on the vro settings, and Click Connect.

192.168.110.1View and configure DNSNslookupServerDefault server:192.168.2.1address:192.168.2.1#53ExitSet up DNS/etc/resolv.confNameServer 192.168.2.18.8.8.8dns1=8.8.8.8Configure a subnet virtual network cardcd/etc/sysconfig/network-scripts/CP Ifcfg-eth0 ifcfg-eth0:0Vim ifcfg-eth0:0device=eth0:0 Modify the NIC nameChange to one of the 2 network segment IPgateway=192.168.2.1SaveService Network restartPing 192.168.2.1Ping to passWhether DNS can be usedNslookup->server192.168.2.1-8.8.8.8ExitNslooku

192.168.110.1View and configure DNSNslookupServerDefault server:192.168.2.1address:192.168.2.1#53ExitSet up DNS/etc/resolv.confNameServer 192.168.2.18.8.8.8dns1=8.8.8.8Configure a subnet virtual network cardcd/etc/sysconfig/network-scripts/CP Ifcfg-eth0 ifcfg-eth0:0Vim ifcfg-eth0:0device=eth0:0 Modify the NIC nameChange to one of the 2 network segment IPgateway=192.168.2.1SaveService Network restartPing 192.168.2.1Ping to passWhether DNS can be usedNslookup->server192.168.2.1-8.8.8.8ExitNslooku