apache loglevel

LogLevel directives Description Control the verbosity of the error log Grammar: LogLevel level Default value: LogLevel warn Context: Server configuration, virtual host State: Core Module: Core LogLevel is used to adjust the verbosity of the information that is recorded in the error log. (see errorlog direc

LogLevel directives Description Control the verbosity of the error log Grammar: LogLevel level Default value: LogLevel warn Context: Server configuration, virtual host State: Core Module: Core LogLevel is used to adjust the verbosity of the information that is recorded in the error log. (see errorlog directives). You c

1 defPage_should_not_contain_list (self, locator, message="', loglevel='INFO'):2 """verifies select list identified by ' locator ' are not found from the current page.3 4 See ' Page should contain Element ' for explanation about ' message ' and5 ' loglevel ' arguments.6 7 Key attributes for lists is ' id ' and ' name '. See ' Introduction ' for8 details about locating elements.9 """TenSe

and content. However, the error log and the access log provide a wealth of information that we can use to analyze the server's operation and where the problem occurs. The file name of the error log is error_log, but if it is a Windows platform, the file name of the error log is error.log. The location of the error log can be set through the errorlog directive: ErrorLog Logs/error.log This file location is relative to the ServerRoot directory unless the file location starts with "/". If

First, modify the Apache default Site Directory After the Apache HTTP server is installed, the default site directory is located in the Htdocs folder under its installation directory, and the default home page is the index.html file for that folder. For example, my Apache is installed inside c:/wamp/bin/apache/apache2

Environment: Window 7, apache/2.2.19 (WIN32) php/5.2.9-1 1. Configure the server name Remove the #ServerName localhost:80 comments from the inside. Re-run the Apache service. The http://localhost:80 can then be accessed through a browser, which means that Apache has been installed and started successfully if the page is displayed. 2. Add PHP Support

Max is from the server with Apache and PHP, do not need to install additional, this article on the relevant configuration is described. First: Apache Enter the terminal and the following command will launch the Apache server: Start sudo apachectl-k start //restart sudo apachectl-k restart Verify: Enter in the browser: http://127.0.0.1, displayed as it works!

The IIS server default port for window is also 80, The Wamp Apache (httpd) default port is also 80, Any port conflict caused by the Wamp open failure, causing wamp the lower right corner of the icon is yellow color (normal open green), You can change the port number of Apache (httpd). Specific programmes To be replaced by: Then restart the Wamp service, or the Wamp itself will be The above descr

1. First, you need to install Apache service, here does not describe how to install. 2. First configure window virtual domain to open hosts Path is C:\WINDOWS\SYSTEM32\DRIVERS\ETC After opening, write the domain name in the inside like www.cms.com 3. Modify the Apache configuration file httpd.conf Found it Remove the note Modify To open state 4. Modify Apa