asterisk sip trunk configuration

Label:Recently studied asterisk configuration, before the SIP account is configured in the sip.conf file, manual writing dead, the current demand, is the dynamic new SIP account, saved in the database.After adding data to the database, use the command SIP show users to not l

This article is from csdn lidp and reposted the famous source. Thank you. For information and technology trends in the VoIP industry, see www.voip123.cn. For the registration function, Asterisk SIP protocol stack provides two services, 1. Asterisk is used as the SIP client and registered with other

calls will be passed to the SIP. in the general configuration of conf. if anonymous incoming calls are not allowed, the incoming calls are rejected directly.* The peer address and port match any peer setting in the SIP. conf type. The incoming call is uploaded to the context specified by the peer.Asterisk also provides an insecure parameter to configure the auth

FreePBX SIP TrunkDockingbackground: PBX1 is a virtual machine running FreePBX, whichnow needs to be connected via SIP TRUNK docking , PBX2, using PBX2 E1 The line calls out the phone. PBX1 192.168.100.1PBX2 192.168.100.2PBX1on the configurationOneConfigurationTrunkNew SIP TRUNK650) this.width=650; "src=" http://s3.51

============================================== View hardware configuration # Dahdi_hardware==============================================View Dahdi Service ConfigurationMore/etc/dahdi/system.confShow the following content, obviously less my PSTN card configuration# Global DataLoadzone = usDefaultzone = usRebuilding the Dahdi service configuration#dahdi_genconfVie

, extconfig.conf Sipusers = Odbc,asterisk,sippeers Sippeers = Odbc,asterisk,sippeers 3, res_odbc.conf [Asterisk] Enabled = Yes DSN = asterisk Username = asterisk Password = asterisk Pre-Connect = yes Limit = 5 4, http.conf [Gene

content of an executable file to the current configuration file. This can be said to be a very useful improvement, because this allows the user to make some processing based on the current system situation, and then generate the corresponding configuration segment, for example, you can generate the current SIP user configura