atheros ar9271

1. PrefaceFind a wireless network card for mercury mw150u, which can be automatically identified under Ubuntu 11.10, but it will not be recognized if it is changed to 10.04. Think about it as if the driver is not installed properly.I found and TP-link TL-WN721N, TL-WN722N, fast fw150u, are using the chip of atheros ar9271.Root @ Ubuntu :~ # Uname-Linux Ubuntu 2.6.32-33-generic # 70-ubuntu SMP Thu Jul 7 21:0

I believe many children's shoes with wireless network card is TP-LINK TP-WN722N, this network card is using the AR9271 Atheros this new product, low power, low heat dissipation, signal stability, wireless NICs using the AR9271 chip also have Fast FW150UD and Mercury MW150UD ...... (well, in fact, these three NICs are one, and the driver can also be used)After www

1. Confirm the wireless card-free chipsetXP (provided that it has installed its XP driver), plug the Wireless card into the PC, Device Manager, select the wireless network card, in the details, select the service, know its chipset is AR92712. Verify the wireless card driver that needs to be downloadedAccording to the following website Https://wireless.wiki.kernel.org/en/users/drivers/atheros We choose ATH9K_HTC Https://wireless.

Ubuntu9.04 download TP-link wn322g + 2.0 (ar9271 chip) unlimited NIC Driver Software required:Htc_9271.fw (previously, ar9271.fw, and now the new version is htc_9271.fw)Compat-wireless-2.6.tar.bz2Reference Document (Official Website ):Http://linuxwireless.org/en/users/Drivers/ath9k_htcHttp://linuxwireless.org/en/users/DownloadHttp://linuxwireless.org/en/users/Drivers/ath9k_htc/devices 1. Copy the htc_9271.

After the installation of CentOS 5.5 system, some people appear to be unable to surf the internet phenomenon, detected by the detection is Atheros AR8151 network card can not recognize, encounter this problem do not be afraid, the following small series to give you the next CentOS 5.5 unrecognized Atheros network card solution. Phenomenon A while ago, install CentOS 5.5 on a computer, the installation pro

The channel set of the Atheros chip wireless network card is generally set to the United States. It is not possible to scan a signal from a 12 or 13 channel. The solution has the following two, decide with one of them by yourself. 1. Install a driver that has been modified by an expert The download address is as follows: http://forums.laptopvideo2go.com/topic/15297-latest-atheros-modded-driver-for-windo

Ralink_Ap_SoC_SDK_3301.tar.bz2 and should be modified from a uclinux basis, SDK Download Address: http://www.tw-mcse.net/mcic/(re-updating the download address), http://www.tw-mcse.net/mcic/Ralink_ApSoC_SDK_3301.tar.bz2 ASUS RT-N56U/RT-N65U has open source code on Google Code, address: https://code.google.com/p/rt-n56u/ Atheros Platform Qualcomm/atheros, too, is using their ap/router SOC programs, such as

Linux MTD (Memory technology Device) subsystem analysisFor Atheros Char deviceRead the Linux MTD Source code Analysis to this part of the overall understanding, combined with the existing code, analysis of how Atheros MTD is used.Linux kernel:2.6.31.Atheros platform:qca9890???Refer to the Linux MTD Source code Analysis , where MTD is divided into 4 layers, from t

Atheros wifi driver analysis, atheroswifi Ar6003 driver document summary 1. wmi: wireless module interface // wireless module structure 2. bmi: bootloader message interface 3. htc: host target communications 4. wps: wifi protected setup 5. CS: connection services module 6. STA: station 7. AP: access point Wireless application: production data and consumption data Wireless module interface (WMI): communication protocol between host and target Hos

I do the network card driver, the main content is to design and improve the rate adjustment algorithm, With the new standard of 802.11 protocol cluster more and more, the rate is more and more high, modulation coding method is also more and more, generally speaking, the higher the rate is more likely to drop packets, the lower the rate is more stable, this is the overall situation, but not necessarily the law, so, only with a fixed rate to send is obviously inappropriate, this requires the rate

Ubuntu version: Ubuntu Server 10.10In the morning of 2016-03-26, the CPU fan of a server computer was not turned on and the power was burnt out (damp reason) ...In 2016-03-28 intends to fix him, so and another colleague, the former colleague's computer, to do server, but only one of the idle, replaced the hard disk, changed the memory. Plug in the network cable, the network cable light is not bright, because the NIC is bad, to pay to buy a separate network card, but do not want to spend money to

Tip: Atheros AR5007EG is supported by BT3 and can be captured, injected, or cracked by wlan. I only provide a solution to the problem and do not provide detailed cracking procedures. The difficulty in this article is the problem of the wireless NIC Driver of the Atheros AR5007EG. I believe many netizens have problems with this. This Nic is indeed not very good and the signal is unstable, however, it does no

Madwifi amp; Atheros-Debian information for the Linux release, which is described below. My notebook cannot be started by wireless after Debian is installed. Later I learned that my wireless card was issued by the company Atheros. By default, Debian only has an Inter driver. Madwifi supports Atheros wireless cards. However, you need to compile the Driver modu

Be abused by this problem, only for the later not to be abused, so write this article.CentOS 6.4 installed on the physical machine and Win7 to form a dual system, but CentOS has been unable to network, a careful look only to find that the network cable interface is not lit at all. Because the NIC driver does not exist! Your execution of the ifconfig command also shows no eth0!The next Driver wizard in Windows is extremely handy for driving problems, but you'll find them on Linux.Now I have found

Different countries and regions have different radio management regulations (Regulatory Domain), and there are also different rules for the division of the ISM 5 GHz band.Regulatory Domian has three major families: the FCC represented by the United States, ETSI represented by the European Union, and TELEC, once again a maverick in Japan (both in the cellular network and WLAN, japan has always been a weird existence ). China adopts ETSI regulations. The specific frequency band management is diffe

Atheros has been acquired by Qualcomm and its original homepage is unavailable. The new homepage is http://www.qca.qualcomm.com/, and no matching driver is found.Download a BBS driver in China, which is applicable to the 813x series. The installation method is extremely simple:Sudo tar-xvf atheros-ar813x-linux.tarCD src/Sudo makeSudo make installCD/lib/modules/2.6.28-11-generic/kernel/Drivers/NET/atl1e/Sudo

Network Card Driver according to ISO-3166 alpha2 National Code (such as US, China CN, Germany DE, Korea KR, Japan JP), the Network Card operating frequency management.Qualcomm Atheros adds the Regulatory Doamin management function to the public part of the NIC Driver. For NIC products sold to different countries, the corresponding country code is written directly in the erasable memory (EEPROM) of the NIC chip. When the driver is working, the code is

Solution to NIC Driver problems of Atheros AR8161/AR8162 in CentOS 6.4 This is a terrible problem, so I will write this article only for later users. CentOS 6.4 is installed on the physical machine and Win7 to form a dual system, but CentOS has been unable to connect to the network, a closer look to find that the network cable interface is not bright. The NIC driver does not exist! Eth0 is not displayed when you execute the ifconfig command! In Window

0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0* Mesh point:0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0* P2p-client:0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0* P2p-go:0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0* P2p-device:0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0supported RX frame types:* IBSS:0x40 0xb0 0xc0 0xd0* Managed:0x40 0xd0* AP:0

Solve the problem that Qualcomm Atheros AR8161 Gigabit Ethernet NIC fails in Linux. The NIC Of My Dell I2330R-168 integrated computer broke down after upgrading a kernel version. ifconfig eth0eth0: flags=4163 Now the arch linux is installed, and the kernel is updated to the latest version. uname -a4.4.1-2-ARCH #1 SMP PREEMPT Wed Feb 3 13:12:33 UTC However, this problem still exists. I suddenly thought that I should go to the kernel site to find the