ccna lab manual

[Lab environment] Cisco Packet Tracer 5.3.2 [PURPOSE] I will not describe the basic commands of Cisco IOS too much. I will focus on some common Cisco IOS skills to improve the efficiency of subsequent experiments. [Experiment topology] Lab procedure] 1. Configure the Cisco Packet Tracer according to the topology and select Console port connection. 2. Double-click PC0 or PC1 and select Terminal Mode for ser

the port speed? View the speed supported by the current interface 10 force 10 Mbps operation 100 force 100 Mbps operation Auto enable auto speed configuration Ccna (config-If) # speed100 # configure the port speed to 100 m Ccna (config-If) # duplex? # Can I Configure port duplex mode? View the modes supported by the current interface Auto enable auto duplex Configuration Full force full duplex operation Ha

ports. Assign an IP address to VLAN Ten and enable it. Refer to the addressing Table. Configure the default gateway according to the addressing Table. Configure VLANs on S2. On S2, create VLAN 10. Assign Student as the VLAN name. Create VLAN 20. Assign Faculty-admin as the VLAN name. Configure F0/1 as a trunk port. Assign ports F0/11 and F0/18 to VLAN and configure both F0/11 and F0/18 as access ports. Assign an IP address to VLAN Ten and enable it. Refer t

DNS master, slave, transfer, subdomain, and delegate lab manuals: before doing the experiment, you must first understand the following concepts 1. what is DNS? DNS stands for the Domain Name System (DomainNameSystem). Simply put, it resolves a domain name into an IP address. 2. what types of DNS are there? Primary Domain Name Server n DNS master, slave, transfer, subdomain and assignment Lab

path that does not exist, the system prompts you to create it.win-4qMethod above, not repeat.Configuration resultsConfigure DFS FeaturesIn Server Manager, click File and storage services.Right-click the server you want to configure (currently win-4q) and select DFS Management.Right-click Replication, select New replication group.Select Multi-purpose replication group (if you need to summarize data for backup, choose another) click Next.Enter the relevant information.Click Add to enter the serve