ccna lab setup

indicates that the configuration is not loaded into the system, often used for Password Recovery 4: Common show commands Ccna # showrunning-config # view the current configuration, including the default configuration of the device Ccna # showstartup-config # view the startup configuration, that is, the saved configuration Ccna # showversion # view the version

ports. Assign an IP address to VLAN Ten and enable it. Refer to the addressing Table. Configure the default gateway according to the addressing Table. Configure VLANs on S2. On S2, create VLAN 10. Assign Student as the VLAN name. Create VLAN 20. Assign Faculty-admin as the VLAN name. Configure F0/1 as a trunk port. Assign ports F0/11 and F0/18 to VLAN and configure both F0/11 and F0/18 as access ports. Assign an IP address to VLAN Ten and enable it. Refer t

[Lab environment] Cisco Packet Tracer 5.3.2 [PURPOSE] Do not describe the basic commands of Cisco IOS too much. Focus on learning Common Cisco IOS skills to improve the efficiency of subsequent experiments. [Experiment topology] Lab procedure] 1. Connect the device to the vro using the Console line according to the topology. 2. Turn off the router power (figure shows the power position of the simulator. Th

Oracle lab environment setup (Windows + Oracle 11g) I. systems and software Windows 7 + Oracle 11g 2. Prepare the installation environment Prepare for ORACLE Installation 1. Delete Environment Variables D: \ oracle \ product \ 11.2.0 \ dbhome_1 \ bin \ Note: Only some oracle environment variables are deleted. Others must be retained. 2. Clear the Registry A. SOFTWARE Item: HKEY_LOCAL_MACHINE \ SOFTWARE \ O

must use the source code for installation. To support GPU, installCuda Toolkit(V> 7.0) andCudnn(V> = 2) Tensorflow only supports GPU with a computing capacity greater than 3.0. --------- Tensflow has been installed. 2. Install tqdmHttps://github.com/tqdm/tqdmthis is an introduction pip install tqdm Version 4.27.0 is installed. 3. Install cv2 pip install opencv-python The installed version is: opencv-python-3.4.3.18 4. Install exifreadHttps://pypi.org/project/ExifRead/ pip install ExifRead The i

Precautions: Modify the Registry disbaledhcpmediasense=1 Public and private modify the priority, and public must set up a valid gateway and DNS. To share a disk, be sure to restart it after DiskPart automount enable, until there is no drive letter. The host file must be written correctly. #public192.168.0.88Server1192.168.0.89Server2192.168.0.90Server3#private10.10.30.88Server1-priv10.10.30.89Server2-priv10.10.30.90Server3-priv#vitual192.168.0.98SERVER1-VIP192.168.0.99SERVER2-VIP192.