centos ceph

Ceph installation in CentOS (rpm package depends on installation) CentOS is a Community version of Red Hat Enterprise Linux. centOS fully supports rpm installation. This ceph installation uses the rpm package for installation. However, although the rpm package is easy to ins

CentOS is the community version of RedHatEnterpriseLinux. centOS fully supports rpm installation. this ceph installation uses the rpm Package for installation. However, although the rpm Package is easy to install, it depends too much, it is convenient to use the yum tool for installation, but it is greatly affected by the network bandwidth. In practice, if the ba

Centos 6.2 64-bit kernel version is 2.6.32-220. el6.i686 and CEpH clients have been integrated in Versions later than 2.6.34. Obviously, centos6.2 does not have a Client client. Since I have installed ceph0.47.2 in Ubuntu 11.10 64-bit, in addition, the kernel version of ubuntu 11.10 is 3.0.0-12-generic, so it naturally contains the CEpH client. For convenience, I

Ceph practice summary: configuration of the RBD block device client in Centos Before proceeding to this chapter, you need to complete the basic cluster building, please refer to the http://blog.csdn.net/eric_sunah/article/details/40862215 Ceph Block devices are also calledRBDOrRADOS. Block Device During the experiment, a virtual machine can be used as the

Ceph practice summary: the configuration of the RBD block device client in Centos, cephrbd Before proceeding to this chapter, you need to complete the basic cluster building, please refer to the http://blog.csdn.net/eric_sunah/article/details/40862215 Ceph Block devices are also calledRBDOrRADOS. Block Device During the experiment, a virtual machine can be used

Deployment Installation Regarding the installation ceph the whole process encounters the question, as well as the reliable solution, the personal test is effective, does not represent the general colleague's viewpoint.I am using the server, so I did not engage in any user issues. The machine is centOS7.3. The Ceph version I installed is jewel and currently uses only 3 nodes.Node IP naming role10.0.1.92 e10

directory, and perform the following operations: Tar-zxvf itsdangerous-0.24.tar.gzCd itsdangerous-0.24Python setup. py install After installing itsdangerous, go to the Flask installation directory and try the last step of the previous Flask installation. Python setup. py develop Whether the message "itsdangerous" is displayed. If the prompt still does not exist, close the current terminal, re-open the terminal, and re-install it several times. After Flask is successfully installed, run

CentOS7 install Ceph 1. installation environment | ----- Node1 (mon, osd) sda is the system disk, and sdb and sdc are the osd disks. | | ----- Node2 (mon, osd) sda is the system disk, and sdb and sdc are the osd disks. Admin ----- | | ----- Node3 (mon, osd) sda is the system disk, and sdb and sdc are the osd disks. | | ----- Client Ceph Monitors uses port 6789 for communication by default, and OSD uses po

First, pre-installation preparation 1.1 Introduction to installation Environment It is recommended to install a Ceph-deploy management node and a three-node Ceph storage cluster to learn ceph, as shown in the figure. I installed the Ceph-deploy on the Node1. First three machines were prepared, the names of which wer

Synchronize the configuration file and keyring of the admin-node to other nodes: Ceph-deploy admin-node node1 node2 node3 Sudo chmod + r/etc/ceph. client. admin. keyring Finally, run the following command to check the cluster health status: Ceph health If it succeeds, the following message is displayed: HEALTH_ OK. Ceph