change raw to jpeg

This article was reproduced from: http://blog.csdn.net/southcamel/article/details/8305873In simple terms,Yuv:luma (Y) + chroma (UV) format, typically sensor supports YUV422 format, that is, the data format is output in y-u-y-v orderRGB: Traditional red-green-blue format, such as RGB565, whose 16-bit data format is 5-bit R + 6-bit G + 5-bit B. G more than one, because the human eye is more sensitive to green.Each pixel of the RAW rgb:sensor corresponds

sensor signal Output YUV, RGB, RAW DATA, JPEG 4 different waysCategory: Camera 2012-12-17 08:59 10085 people read reviews (5) Favorite reports In simple terms,Yuv:luma (Y) + chroma (UV) format, typically sensor supports YUV422 format, that is, the data format is output in y-u-y-v orderRGB: Traditional red-green-blue format, such as RGB565, whose 16-bit data format is 5-bit R + 6-bit G + 5-bit B. G more than

One, JPEG is a compressed photo The basic difference is that the RAW file will fully retain the image of each pixel message and information, but JPEG is a camera based on a compromise compression, so the size of the two files are significantly different, RAW files can be

Q: After I take a picture of JPEG format, is there any way to adjust the white balance of the photo? Or does a similar adjustment only apply to RAW format? A: Strictly speaking, you'd better use raw format to shoot, so that in the later editing process, the balance of the dialogue in the lossless adjustment. Since the automatic white balance is not foolproof, th

From the serial camera to get an image of the JPEG data, I copied the data to TXT document, want to change the data into an image, in VC + + should do? Read some information, some people said to save directly to JPG format, so I changed the filename suffix. txt to. jpg, but "no preview" is displayed when it is opened. I have implemented the following programs in VC + +:FILE *pfile=fopen ("Tst.txt","RB");//t