cisco 2600 terminal server

Cisco network module slot, and a new advanced integration module AIM) slot. Cisco 1600. The WAN interface cards used by the Cisco 2600 module and the Cisco 3600 series routers support a variety of serial ports, isdn bri, And CSU and DSU) and other options to achieve master-

A router is a commonly used network device, but how do we configure it? How can we achieve ADSL and PPPOE dial-up connections? This document provides detailed configuration commands. Implement ADSL and DHCP on Cisco 2600 Series Router The following settings are exported on the vro that has been successfully set. The Ethernet port is used for dialing and NAT. ! Version 12.3: Service timestamps debug datetime

, after logging in R1, you cannot use ctrl+shift+6, and then type "X" key to return to terminal in this way. It seems Packer Tracer still have a lot to be perfected.Write here, the configuration of the terminal access server is done. Because I am also a beginner, writing these things is also to give themselves a summary of learning, so inevitably there is a wrong

This article uses the Cisco 2509 Terminal Server to log on to other machines. how to configure the server? The following article describes the configuration process in detail and provides configuration commands. Use Cisco router reverse Telnet for

"Connection refused by remote host" still appears in telnet host 1015, and an asterisk appears in front of tty. In this case, "clear line tty 68" is required" Terminal Server Configuration: The asynchronous port of the terminal server is connected to the console port of the test router using a

Cisco Packet Tracer 6.0 configures the Terminal Server method:Look at my topology first.650) this.width=650; "src=" Http://s1.51cto.com/wyfs02/M02/7D/6A/wKiom1bnyXWRIJP5AAAktArJM2M738.png "title=" capture. PNG "alt=" Wkiom1bnyxwrijp5aaaktarjm2m738.png "/>Server configuration:1, configure the IP address, and client side

Use Cisco router reverse telnet to do Terminal ServerIf we have more than one router to do the experiment, if it is according to the control line of a single configuration will be very troublesome, so we need to configure a Terminal server to log on to other machines here, the following practices:Install the eight claw

protocol router (config-router) #network 192.168.2.0//Specifies the network that needs to be advertised (located in the routing interface) router ( Config-router) #network 10.254.10.0router (config-router) #exit/*=part3dhcp Relay Agent configuration */ Router (config) #service dhcp //enable DHCP feature router (config) #inter f0/0 //Enter No. 0 module NO. 0 port (Fast Ethernet interface) Router (config-if) #ip HELPER-ADDRESSNBSP;10.254.10.1NBSP;NBSP;NBSP;NBSP;//forwards DHCP request packets in