cisco 3550 layer 3 switch

Network Environment: A 3550EMI switch is divided into three VLANs. vlan2 is the network where the server is located and is named server. The IP address segment t-[/[Xm1S3 is 192.168.2.0, subnet mask: 255.255.255.0, Gateway: 192.168.2.1 the Domain Server is windows 2000 advanceserver and serves as a DNS server. The IP address is 192.168.2.10, vlan3 is the network where client 1 is located, the IP address segment is 192.168.3.0, The subnet mask is 255.2

#十二步 Save ConfigurationDestination filename [startup-config]?Building configuration ...[OK]switch#-=--------Switch#reload#重新启动-----------Press RETURN to get started!00:00:14:%spantree-5-extended_sysid:extended sysid enabled for type VLAN00:00:17:%sys-5-config_i:configured from memory by console00:00:17:%sys-5-restart:system restarted--Cisco Internetwork Operating

The Cisco layer-3 switch is another core switch developed by Cisco. It aggregates the bandwidth of the backboard of the switch that is stacked together, in this way, the total backplane

For complete syntax and application information about this chapter, seeCatalyst 3550 Multilayer Switch Command ReferenceAnd Cisco IOS Interface Command Reference For Release 12.1. Understanding Interface Types This section describes different interface types and some reference content for configuring these interfaces in detail in other sections. Other section

Layer-3 Switch for Cisco switches Although single-arm routing solves the communication problem between different VLANs, it also has its fatal defects: -The single arm itself is the Backbone link of the network, which is easy to form a network bottleneck. -The sub-interface relies on physical interfaces, and the applic

A typical LAN is to connect a core switch with a layer-3 Switch to several Branch switches (not necessarily with layer-3 switching ). We assume that the core switch name is com, and the

[Cisco] DHCP relay, layer-3 Switch VLAN Routing PracticeThe experiment topology uses the GNS3 0.8.6 simulator to build a DHCP server using Red Hat 6.5. The experiment requires configuring a layer-3

interface that will be configured as a three-tier interface Step 3 No Switchport To get the physical interface into layer three mode Step 4 IP address ip_address subnet_mask Configure IP addresses and subnet masks Step 5 No shutdown Step 6 End Return Privileged Mode Step 7 show interfaces [Interface-id]show IP inter

1) layer-2 Exchange Technology The layer-2 switching technology is relatively mature. The layer-2 switch is a data link layer device that can identify MAC locations in data packets.Address information, which is forwarded based on the MAC address, and the corresponding MAC ad

Simply put: Layer-1 switchOnly physical layer protocols are supported (one phone-controlled switch can be called ???)L2 SwitchSupports physical layer and data link layer protocols, such as Ethernet switches.L3 SwitchSupports physical