cisco easy vpn configuration guide

Application Introduction The PPTP VPN PC to site mode provides the terminal with a secure tunnel to the Headquarters network. If you are on a business trip, you can connect to the Internet, use the terminal's own VPN client dial-up connection, and establish a secure tunnel for data transmission. This article describes how to build a PPTP VPN se

, other parameters can be modified according to need. Note: The local address is the address of the VPN client accessing the router, and the maximum session is that the account can be used by multiple computers at the same time. [3] set up the PPTP Server Click on VPN > PPTP > PPTP Server , click on, set as follows: Note: The ser

following example:Example 1. Pix525 (config) # fixup protocol ftp 21Enable the ftp protocol and specify the ftp port number as 21.Example 2. Pix525 (config) # fixup protocol http 80Pix525 (config) # fixup protocol http 1080Specify port 80 and port 1080 for the http protocol.Example 3. Pix525 (config) # no fixup protocol smtp 80Disable the smtp protocol. D. Set telnetTelnet has a version change. Before the pix OS 5.0 (the version number of the pix operating system), you can only access the pix f

Cisco Wireless AP Configuration Guide requirements in complex enterprise environments Overview: using Cisco AP to build an enterprise wireless LAN, users' laptops do not need to be added to the AD domain,You can log on to the wireless network. the user name and password of the domain are used for Logon. SSIDS hides the

Cisco routers use many methods in configuration. Using SSH instead of Telnet cisco makes it easier for us to understand the configuration of cisco routers and other knowledge points. Replacing Telnet with cisco router

Https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/7-x/security/configuration/guide/b_ Cisco_nexus_9000_series_nx-os_security_configuration_guide_7x/b_cisco_nexus_9000_series_nx-os_security_ Configuration_guide_7x_chapter_01.html Feature Description Changed in Release Where documented IP ACLs Added IPV6 Wildcard mask support for access lists a

the ports of the corresponding vswitch as required in table 1. To verify our configuration, you can use the show vlan command in privileged mode to display the configuration you just made and check whether it is correct. The above describes the VLAN configuration of the Cisco Catalyst 1900 switch. The VLAN

to say, after you set the password for level 1, you will be asked to enter the password next time you connect to the switch and enter K, this password is the password set for level 1. Level 15 is the privileged mode password that you enter after you enter the enable command. Step 2: Set the VLAN name. Because the four VLANs belong to different switches, the command for VLAN naming is VLAN 'vlan No. 'name' vlan name ', the following code configures VLAN 2, VLAN 3, VLAN 4, and VLAN 5 on the Switc

Recently, a number of Cisco ucs c Series servers have been added. After two weeks of deployment and installation, the server can finally be tested. This document briefly introduces the network configuration of the Operating System (centos 6) in the Cisco UCS server. It can be simply considered that this article describes the network