cisco network topology diagrams

manage the switch via browserHigh-End Series products : The Formation of the future development of the architecture, to provide operational consistency, improve IT Infrastructure Utilization, improve network uptime, to build a high-bandwidth, high-reliability network protection. Work Assignment DescriptionA company has purchased a Cisco Catalyst 2950 Switch to b

Hot Backup Routing protocol Hsrp:cisco Private protocolEnsures that when the network edge device or access link fails, the user communication can be quickly and transparently restored to provide redundancy for the IP network, by using the consent virtual IP address and virtual MAC address, two or more routers on the LAN segment can be used as a virtual router for external services.HSRP enables

Tags: cisco/remote configurationIn actual work our routing and switches are always placed in the room to facilitate our work we need to configure the routing and switches so that we can configure the routers and switches in the office or at home.This is a simple network topology diagram where a computer-connected route configures the switch across

"help address"Switch (config-if) #eSwitch (config) #in VLA 20Switch (config-if) #ip helper-address 192.168.50.1Switch (config-if) #eSwitch (config) #in VLAN 30Switch (config-if) #ip helper-address 192.168.50.1Switch (config-if) #eSwitch (config) #in VLAN 50Switch (config-if) #ip add 192.168.50.254 255.255.255.0//Configure IP for VLAN50Switch (config-if) #no shSwitch (config-if) #eSwitch (config) #in VLAN 40Switch (config-if) #no shSwitch (config-if) #ip add 192.168.40.254 255.255.255.0//Configu

First, you want to access the router through Telnet, you need to first configure the router through the console port, such as IP address, password, etc.For example, I set up an experimental topology ( It is important to note that the PC and the router to connect with the intersection, and then enter the interface mode to activate the port, the image shows the green point as the normal activation port )650) this.width=650; "Src=" Http://s3.51cto.com/wy

Tags: IP source GuardNetwork topology structure:Scenario Description:Core layer: Each VLAN interface gateway is at the core layerAggregation layer: Two stacks, port-channel to the core layer, Port-channel Xia Lian to the access layer, do not run dynamic routingAccess layer: Two port Port-channel, link to two aggregation switches respectivelyObjective:Prevent internal enterprise network from accessing DHCP s