cisco optical transceiver

Nowadays, optical transceiver network devices are increasingly used in our network engineering. They are used in small-scale optical fiber trunk connection solutions, so it is better to use optical fiber interfaces for switches in large-scale optical fiber trunk. Because of

When using a fiber-optic transceiver, it is necessary to pay attention to some problems in order to make the use of fiber-optic transceiver better. 1. View whether full duplex or half-duplex is supported. Some of the market can only use a full dual public environment, can not support Half-duplex, such as receiving other brands of switches or hubs, and it uses Half-duplex mode, otherwise it will cau

it is always bright, the optical port has a signal. If it is not bright, the optical port has no signal. FL Optical Transceiver optical fiber port and peer device Optical Fiber port connection/activity indicator.

Indication of the indicator meaning:Power (green): "Solid" indicates that the fiber transceiver is in power state;LFP indicator: "Solid" indicates that the LFP function is turned on, "normally extinguished" means that the LFP function is closed;Fx_link/act (green): "Solid" indicates that the fibre port connection is valid, "flashing" indicates that the transceiver is receiving or transmitting data from the

Cisco-Huawei Optical Module Classification Comparison summary: This article introduces: Cisco GLC-SX-MM,GLC-LH-SM optical Module and other product parameters and pictures, Huawei Optical module model and classification knowledge.Optical Module Classification and introduction

Tags: Cisco MDS zone san Configure a Cisco MDS Optical Fiber storage switch (MDS multilayer Director Switch multi-layer optical fiber array switch)General process: 1: Create a vsan, add the port to vsan2: create a zone, add the port to zone3: Create a zoneset, add the zone to the set, and enable zoneset4: Enable all

CISCO mds FC optical fiber switch configuration reference(1) There are several concepts that must be clarified (different from brocade ):(1) brocade divides zones directly. While mds divides zones under vsan, mds can divide several vsan first, and each vsan includes several zones.(2) brocase: the default port is open, while the default port of mds is closed.(3) mds has a Default zone: "The Default Zone ". i

High intelligence, high availability, and high reliability are the characteristics of multi-layer intelligent optical fiber switch. Although its technology is not very mature yet, it has been recognized by people. Cisco Systems recently announced that it will launch the CiscoMDS9100 series of multi-layer smart Optical Fiber switches this fall to meet the needs of