cisco pbx server

For a long time did not write blog, today to write an article to fill the number, ha ...Now let's use a TFTP server to backup and restore Cisco device Files!!The tools we want to prepare are:Cisco TFTP tool (please download the attachment)GNS3/CRT (this please find your own Niang)When you have the tools on top, we're going to start!1, configure GNS3 Road by the TFTP device connected:Below we will prepare th

Cisco Packet Tracer 6.0 configures the Terminal Server method:Look at my topology first.650) this.width=650; "src=" Http://s1.51cto.com/wyfs02/M02/7D/6A/wKiom1bnyXWRIJP5AAAktArJM2M738.png "title=" capture. PNG "alt=" Wkiom1bnyxwrijp5aaaktarjm2m738.png "/>Server configuration:1, configure the IP address, and client side in the same network segment(config) #interfa

downstream interfaceLimit rate speed, calculated as follows:assuming that 2960 is the port, so the simple set speed limit is*15=720 Note: IP DHCP snooping limit rate needs to be set only if the DHCP snooping converged switch or core is enabled. If there is a large number of access layer switches under a core or aggregation switch, the speed limit setting needs to be noted because the maximum limit rate for the port is 2048, soyou need to adjust the limit rate on the access layer port to make

EnConf tClock timezone gmt+8 #设置北京时间ExitClock set HH:MM:SS Day MONTH #设置当前时间Service Timestamps Debug Uptime #开启debug调试模式Service Timestamps log datetime localtime #开启log日志增加时间戳Log on #启动log功能Loggin 192.168.1.100 #配置日志发送到192.168.1.100 on the hostLoggin facility Local2 #将记录时间类型定义为local2Loggin Trap 7 #cisco device alarm level is divided into 0---7 levels, 0 levels highest, 7 level lowestLogging Source-inter loopback0 #指定log日志记录内容发送的源地址为Loopback0的IP地址Servi