cisco policy based routing next hop

Many people may not have a special understanding of setting policy routes. So I have studied VLAN-Based Configuration Policy routes. Here I will share with you, hoping to help you. With the popularization of networks, how can small-sized enterprise local networks spend less money to implement more complex network functions in the case of a shortage of funds to me

Policy-based routing is more powerful and more flexible than traditional routing, enabling network administrators to select a forwarding path based not only on the destination address but also on the message size, application, or IP source address. In the practical network a

"Topology and software used" The switch used in this paper is H3C Simulator, the download address is as follows: Http://forum.h3c.com/forum.php? Mod=viewthreadtid=109740highlight=h3c%e6%a8%a1%e6%8b%9f%e5%99%a8 interested friends can download on the forum Demand R1 respectively and R2,R3, such as the above figure directly connected, R2 and R3 routing is not up to, through the policy route control from t

In LINUX, the IP address control instance based on the routing policy-Linux Enterprise Application-Linux server application information. The following is a detailed description. I. background description LINUX is a gateway server with three NICs Eth1 is bound to an IP address of 172.17.0.0/16. The IP address of this network segment can be accessed through 172.17

AR28/AR46 series routers control all TCP packets received from interfaces E3/0/0 on the basis of the typical configuration of the source address policy routing [requirement, the serial port serial1/0/0 is used to send other messages. Other messages are still forwarded by searching the route table. Node 5 indicates that Ethernet packets matching acl 3101 will be sent to the serial serial1/0/0; node 10 indica

feature can be implemented through several configuration steps: 1 The configuration of 2 WAN interface is Ethernet link, in this case, the Ethernet direct connection method is used as an example; 2 Configure the static route and set the same priority; 3 Configure Policy Routing to distribute traffic evenly to 2 links. 2 points to note The two routes have the same priority. The configuration

configuration steps to implement this feature:1) configure two WAN interfaces as Ethernet links. In this case, the Ethernet direct connection is used as an example;2) Configure static routes and set the same priority;3) configure a policy route to evenly distribute traffic to two links. 2. Notes The two routes have the same priority.Configure the rule that the route address is an even number and the address is an odd number.The priority of a