cisco power stack cable

Must use a dedicated cable Example of a fool-type configuration:1: Physically connect the stacking cable, the connection method for Master's Stack1 is connected to the slave stack2 above. See2: Open master, do not make any configuration. And so on after the full boot.3: Open the slave machine.4: Do not make any configuration. (line plug good, power on a

Cisco 3750 switch stack configuration points 3750 stack is a real stack, the Catalyst 3550 series uses StackWise technology, it is an innovative stack architecture, A 32 Gbps stack interconnection is provided to connect up to nine

The Cisco layer-3 switch is another core switch developed by Cisco. It aggregates the bandwidth of the backboard of the switch that is stacked together, in this way, the total backplane of the switch stack is the sum of the bandwidth of several stack switches. Note that not only the ports used are different, but the ca

CISCO 3750 Dual Switch stack operation, cisco3750 dual Double switch stack operation I. Basic Requirements: The ios version must be consistent with the dedicated stack module and stack cable, and the maximum number of stacks is 9.

, and the slot number is different) Iii. Stack instances: 1: The stacked cables are physically connected. The connection method is master stack1, which is connected to slave stack2. 2: enable the master without any configuration. . 3: Server Load balancer is enabled. 4: No configuration is required. Line plug, automatic stacking election upon startup, master is highlighted) Note: You can also configure stacks first, such as IP addresses and priorities

Preface:The 3750 stack, unlike the 3550 stack, is a real stack. The Catalyst 3750 series uses StackWise technology and is an innovative stack architecture that provides a 32 Gbps stack interconnection, connect up to nine vswitches and integrate them into a unified, logical,