cisco router commands pdf

, configure the appropriate IP addressrl# Ping 10.0.0.2 Use the ping command to view the connectivity of neighborsrl# show ip route to view the routing table, you can see the routing information in C, which is a direct-attached routing information;You can see the routing information at the beginning of R, which is the routing information learned from RIP, and you can seeI begin with routing information that replaces the routing information that begins with R because the IGRP pipeDistance is 100,

Router configuration-CGMP To configure cgmp on a cisco router: Dallasr1> (config-if) # ip cgmp Configure a multicast router to add it to a specific multicast group: Dallasr1> (config-if) # ip igmp join-group-address Disable CGMP: Dallasr1> (config-if) # no ip cgmp Start the cgmp on the switch: Dallasr1> (enable) set cg

neighbors detail.Show CDP Entry * Protocols shows the IP address of a direct-attached neighbor.Show CDP Entry * Version shows the iOS version of the Direct connect neighbor.Show CDP traffic shows the CDP packets sent and received by the device.Show CDP interface shows the CDP information used by each interface, including the package type, timer, and hold time of the line.Close CDP Service no CDP run, turn off CDP for an interface in interface mode no CDP enableWhen you see the above command, im

configurationRouter>enableRouter#configure TerminalRouter (config) #interfiguer f0/0Router (config-if) #ip address 192.168.1.2 255.255.255.0Router (config-if) #no shutdownThen back into privileged modeRouter#write Memory for storageThen test if you can ping the IP of the serverRouter#ping 192.168.1.1Then make a copy.Router#copy Running-config TFTPAddress or name of the remote host[]?192.168.1.1 enter the IP of the server after the question markThen leave the default hit enter to finish.4.

Tags: Cisco switchBasic configuration and management of switches• Technical Principles• The switch is managed in two basic ways: in-band management and out-of-band management.• The console port management switch through the switch is out-of-band management, which does not occupy the network port of the switch, and the first configuration switch must be configured with the console port.• In-band management via remote telnet, dialing, etc.• The switch's

This article introduces some examples of Huawei 3COM vro commands. in the network, the network administrator should know the status of the vro at any time for timely troubleshooting. The command of the Huawei router is similar to the show command of cisco. Making good use of him can greatly facilitate our daily work.Aaa specifies AAA (authentication, authorizatio