cisco sg300 console

Network administrators often need to connect to a vro to perform configuration verification, and statistical data review on the Cisco router. There are many methods to connect to a Cisco router, such as configuring a port, a secondary port, or using Telnet. However, I like to connect to the vro through the Console port for related management and configuration. Th

The console port is a port for each network management device. By default, authentication is not performed and plug-and-play is enabled. To ensure security, we can authenticate the console port, there are two authentication methods: 1. password 2. user name + Password Take Cisco configuration as an example: 1. Password Line

Configure Console port Password Sw (config) # line console 0 Sw (config-line) # password cisco Sw (config-line) # login Configure the privileged mode password Sw (config) # enable password cisco plaintext Sw (config) # enable secret cisco ciphertext Encrypt plaintext passw

The built-in tool "HyperTerminal" can be used directly under XP, and installation SECURECRT need to be downloaded in Win7 or later.This article assumes that the SECURECRT has been downloaded and installed.First, connect your computer to the console line. Because many laptops do not have a serial port configured at present, the console line is now connected to a serial port to the USB port line, and then via

CCNP preparation is imminent, with the book "Cisco Network Laboratory-routing, Exchange Experiment Guide" review of these basic experiments, simulation software with the packet Tracer 5.0. Diagram topology: Use the reverse line (rollover) to connect the PC's RS232 interface and the router's console port. RS232 Mouth as shown: Super terminal settings on PC: If successful, you can see the router's