cisco switch sg300 28

machine telnet switch1. Connect the PC1 with a straight line to the FASTETHERNET0/3 port of the switch.2. Open IP configuration on the desktop of PC1, select the static configuration, set the IP address to 172.16.10.100, the subnet mask is 255.255.255.0.3. Open the "command Prompt" on the PC1 's "desktop".4. Remotely log on to the switch using the telnet command at the command prompt (

Hack password principle: Delete Password only, do not destroy configuration#本文中的 # Indicates the meaning of the comment#第一步. Connect the console port of the switch to the terminal#第二步. Press and hold the mode key on the switch panel while inserting the power supply until the SYS light does not flash, and then release the mode keyC2950 Boot Loader (c2950-hboot-m) Version 12.1 (6) EA2C, RELEASE Software (FC1)

-265124472 Jul 2018 02:36:21 +00:00 cat3k_caa-rpcore.16.03.06.spa.pkg15514-rw-9095808 Jul 2018 02:36:23 +00:00 cat3k_caa-srdriver.16.03.06.spa.pkg15510-rw-4737 Jul 2018 02:37:15 +00:00 cat3k_caa-universalk9.16.03.06.spa.conf15515-rw-211675764 Jul 2018 02:36:25 +00:00 cat3k_caa-wcm.16.03.06.spa.pkg15513-rw-13423228 Jul 2018 02:36:23 +00:00 cat3k_caa-webui.16.03.06.spa.pkg15508-rw-4748 Jul 2018 02:37:29 +00:00 packages.conf.00-1621966848 Bytes Total (453984256 bytes free)The above shows you can se

The IT Certification Examination Resources Network has collected a number of training materials for Cisco agents, including answers to pre-sales questions concerning routers, switches, IP/TV, firewalls, VPNs, network management, HFCs, VOIP, and equipment procurement., it can also be used as an entry-level document.12. Question: Which switches Does Cisco currently support layer-3 switching?Answer: Catalyst 2

numbers to this value. Each vswitch has a baseline MAC Address. Run the following command to see Sw2 # show versionBase ethernet MAC Address: 00: each port of the 0D: 28: 61: 35: 00 switch has a MAC address, which is obtained by adding the port number to the Base (baseline) MAC address. Show interfacef0/1 this command can see the MAC address of the switch port t

/25Interface index 10126 orresponding to GIGABITETHERNET1/0/26Interface index 10127 orresponding to GIGABITETHERNET1/0/27Interface index 10128 orresponding to GIGABITETHERNET1/0/28Interface index 12001 orresponding to Null0Interface index 12002 orresponding to FastEthernet0The commands are annotated as follows: #/usr/lib64/nagios/plugins/check_traffic.sh [-v] [-6] [-I Suffix] [-F s| S] [-P N] [-r]-v 1|2c|3-c snmp-community-h host [-l]-I interface-w in,out-warning-value-c In,out-critical-valu E-k