cisco syslog messages

Logging Cisco device logs using syslogThe following configuration describes how to send logs from a Cisco device to a syslog serverDevice#conf TDevice (config) #logging onDevice (config) #logging the IP address of the A.B.C.D//log serverDevice (config) # logging facility Local1Facility identification, RFC3164 the local device identification specified as LOCAL0-LO

First, start the log service (1) Start log logging on Note: by de fault, the logging level was set to 3 (error). The default log level is 3 (error) (2) Set log level logging Trap Severity_level (1-7) (3) Check log settings show logging second, test log output Test the log information output by following these steps: (1) Log information is sent to the console port. Logging Console 7 Quit This test will generate the following syslog information 111005:

messages. % DUAL-3-SIA: Route 171.155.148.192/26 stuck-in-active state in IP-EIGP 211. Cleaning up % LANCE-3-OWNERR: Unit 0, buffer ownership error Note that not all messages involve failures or problems. Some messages display status information. For example, the following message only indicates that the isdn bri 0 interface is connected to a specific remote dat