command to sync time with ntp server in windows

server. Note: Before you work, back up the Registry file. 1. Enter the regedit command in the Start menu and open the registry settings screen. At this time, make sure to back up the Registry file. 2. Modify the key values of the following options HKEY_LOCAL_MACHINE \ SYSTEM \ CurrentControlSet \ Services \ W32Time \ TimeProviders \ Enabled in NtpServer is set

Set up NTP time server and ntp server 1.1 NTP Introduction Network Time Protocol (NTP) is a Protocol used to synchronize

The local clock in the Xen Linux machine is by default (done) synchronized with the physical host clock, in order to change the time it uses the Sync Service for NTP, the kernel parameters must be set by the virtual machine:Shell CodeEcho 1 >/proc/sys/xen/independent_wallclock The/etc/sysctl.conf configuration file in the virtual machine adds the following two a

This article mainly records the usual accumulation of things about NTP.In order to connect to the NTP server, the device must be connected to the network, setting a different method, Conlio here. There are many NTP servers, but some are not. The test is 202.120.2.101, which is the Network Center NTP

is a group of NTP server clusters with six servers located at Shanghai Telecom. This service is the second free API service for API. BZ following the free SMS sending interface of http://sms.api.bz mobile mail. Client settings: 1. the Linux server can use the ntpdate command to synchronize with the

synchronization will decrease correspondingly.Reach: This is a octal value that is used to test the connection to the server and increases the value of each successful connection.Offset: This is the most critical value, which tells us the time difference between the local machine and the server. The closer the offset is to 0, the closer we are to the server.Jitt

is actually very simple, we'll pack the rpm we need.If you have already installed an NTP package, you can use this command to determine:[Email protected] ~]# Rpm-qa | grep NTPntp-4.2.2p1-9.el5_4.1chkfontpath-1.10.1-1.1The above code indicates that an NTP package has been installed, otherwise it is installed in the following way:Code:# RPM-IVH

: * 11484/ntpd After the restart, you have to wait a few minutes or ten minutes to synchronize time, # Ntpdate 192.168.8.100 11 Aug 11:38:30 ntpdate [7619]: adjust time server 10.17.1.60 offset 0.000178 sec If the test is performed immediately after the restart, the following occurs: # Ntpdate 192.168.8.100 11 Aug 11:05:28 ntpdate [1, 7326]: no

1th Chapter ntp1.1 NTP IntroductionNTP, Network Time Protocol, is a protocol that is used to synchronize the time of each computer in a network. Its purpose is to synchronize the computer clock to the World coordinated UTC, its accuracy in the LAN up to 0.1ms, in most places on the Internet its accuracy can reach 1-50ms.1.2 N