dell laptop bios key

Optiplex Desktop Series 1, start the computer, when you see the Dell splash screen, press "F2" key to enter the BIOS; 2, press NUM LOCK (Digital lock), Caps lock (case lock), Scroll Lock (Volume screen lock) three keys to the keypad above the corresponding three lights lit; 3, on the premise that three lights are all lit, restore the

Tag: Dell Reset BIOSReference Document Address: http://tieba.baidu.com/p/721711019Optiplex Desktop Series1, start the computer, when you see the Dell splash screen, press "F2" key to enter the BIOS;2, press NUM LOCK (Digital lock), Caps lock (case lock), Scroll Lock (Volume screen lock) three keys to the keypad above t

Dell Laptop win8.1 How to install win7 system with u disk First, the matters needing attention 1, the transformation of the hard disk partition form needs to clear all the disk data, backup computer files 2, after the Win7 can not restore the original win8.1, to restore to the Dell after the sale of recovery Ii. Modifying the

Dell PowerEdge r210 into BIOS Modified disk controller (SATA Controller) interface modePress F2 after power on to enter the BIOS settings, such as:BIOS Setup Main interface:Use the up and down keys to move the cursor to "SATA Controller" and press ENTER to enter the interface mode setting.Use the up and down keys to move the cursor to "SATA Controller", use the l

The charge number of the battery is 300 times or more for full charge. In the case of incomplete charge, such as the meeting completed, the use of half of the electricity, connected to the external power supply, will automatically recharge, these incomplete charge on the battery life is generally not much impact, but long-term accumulation will also reduce the performance of the battery. It is recommended that the battery be fully used and then recharged. Now the E-series notebook has been

1. Press ESC or F12 to enter the BIOS, open the Boot tab, and change the launch CSM to Enabled, but at this time the launch CSM is disabled and is not editable in the gray state.2. Press the arrow key to switch to the Security tab, locate the Secure BOOT control entry, enter, change the enabled to disabled, and then go back to the BOOT option, at which point the launch CSM is still non-editable.3. Press F10

laptop win7 system computer for battery calibration in BIOS The specific methods are as follows: 1, first in the Win7 system boot into the BIOS Setup Panel, and then switch to the "Power" tab. Then move the cursor over the Start Battery Calibration tab, and then press the "Enter" key to perform the action. 2,