enable usb debugging

ProgramDebugging can improve ModificationCodeBut ASP. net cannot start server debugging, which has plagued many people. I used to be very annoyed with this problem, but now, you only need to do the following two points to start server debugging:First, you must have the XML file web. config and set the debug attribute to true.2. Enable "Integrated Windows Authentication" for the IIS Site ". the method is: go

When you encounter a pea clip, stay on when you open the USB debugging interface, follow these steps: First of all, please determine whether you have turned on the "usb debugging mode, please refer to the 3rd part of this post. If you have turned on "usb debug mode but sti

Enable Consolelog/ For SMTP debugging, enter the following command on the console: Show Source 1 > Start consolelog # console logging is now enabled. 2 > Set config debug_threadid = 1 3 > Set config smtpclientdebug = 1 4 > Set config debugrouter = 3 Disable consolelog/SMTP debugging and enter the following command on the console: Show Source 1 > Sto

Charm Blue 3s developer options where? Click on the Mobile desktop "settings"-"Settings Interface"-"about mobile phone"-"version number" of the project Bar, in the version number of the project bar, 7 consecutive clicks, you will be prompted to open the developer option. This has been turned on, back to the Setup interface, you will find that there are "developer Options", we click to go to see. Charm Blue 3s open usb Debug Graphics Tutor

1. Under the Standby page, click "Application". 2. Click "Set". 3. Slide the phone screen up with your finger and select "Developer Options". 4. Slide the slider to the right of the developer options to the right, when the ScreenTip "These are for development purposes only." When it can cause errors in your device and its application, click OK. 5. Click "USB Debugging" to hook it

1. Click the "Application" in the bottom right corner of the mobile desktop status as shown in the following figure.2. After entering, we find the "set" button and then click on it.3. Then click on the right side of "more" and then select "About the Device" menu click it to enter. As shown in the following figure 4. Now we just click on the "build number" 7 times, will prompt "developer mode is enabled" (Note to continuously click Oh, if not valid can try more until the show can be shown).

1. In the mobile phone we find the "application" icon to enter, if you are not on the phone desktop we press home button back to the desktop. 2. Into the application management interface we will see in the middle of the "Set" icon click to enter. 3. Then in the setup we will find that there is a "General" menu click and click on "about the device" as shown in the following figure. 4. Now we see a "build number", we just click 7 times for a quick connection until we see "developer mode enabled

1 We in TCL Mobile phone found in the desktop "set" open after we click on the settings "all set" open will see a "about the phone" and then we find "version number" continuously click 7 times. 2 If we click on the "version number" did not see "You are in the developer mode" We can then click, directly to see "You are in the developer mode" back to the Settings panel click "Developer Options" as shown in the picture. 3 then in the open interface we will see that there is a "