end switch

Speed-limiting switches are typically on three or more switches, and the new switch model two-tier device since 2008 can achieve the QoS speed limit of 1Mbps, such as the Cisco 2960 series switches. After this, most of the domestic standard

Experiment on single-arm routing using a layer-3 Switch In the real environment, sometimes the gateway is not necessarily enabled on the router, sometimes the single-arm routing function is not necessarily connected to the interface on the router,

Today, the tutor told me about the company's network topology, related to the switch, the basic concept of routers and principles, I am not very clear, so on the internet to learn the information to learn a bit, and then feel that this article is

* Vlan configuration ideas (access and Trunk) (1) create a Vlan and configure a static VLAN on an IOS-based switch: switch # vlandatabaseswitch (vlan) # vlanvlan-numnamevlan-nameswitch (vlan) # exitswitch # configureteriminalswitch (config) #

Master the high-end switch cascade to instantly become a master of the network, previously introduced the relevant knowledge. After the publication of the stack and cascade of switches, we have received a number of emails from many readers to

Two-layer switch: Two-layer switching technology is a mature development, two-layer switch is a data link layer device, can identify the MAC address information in the packet, according to the MAC address forwarding, and the MAC address and the

With the increasing popularity of Mbit/s, Gbit/s, and even Mbit/s local area networks, broadband MAN networks and even broadband wide area networks are widely used. Whether it is Intranet, exclusive, or residential intelligent networks, it is

Two-layer switching technology is a mature development, two-layer switch is a data link layer device, can identify the Mac in the packet Address information, forwarding based on MAC addresses, and recording these MAC addresses with corresponding

Two-tier switch:The second layer switching technology is more mature, two layer switch is a data link layer device, can identify the MAC address information in the packet, according to the MAC address to forward, and these MAC addresses and

1) layer-2 Exchange Technology The layer-2 switching technology is relatively mature. The layer-2 switch is a data link layer device that can identify MAC locations in data packets.Address information, which is forwarded based on the MAC address,