how to configure ip address in linux in vmware

The two virtual machine IP addresses are set to: 192.168.33.11, 192.168.33.12.Set up the virtual ip:192.168.33.149 with the following command.sudo ifconfig eth1:0 192.168.33.149 netmask 255.255.255.0 upDelete the virtual IP with the following command:sudo ifconfig eth1:0 downThe above commands are not permanently modified and need to be permanently added to the

Copy Code code as follows: @ ECHO off @ ECHO. by Lost63 2010.2.23 @ ECHO. function: Batch configuration IP address. PS: Local connection 2 is generally "local connection", please change according to the actual situation! @ ECHO. Description @ ECHO----------------------------------------------------------------------- @ ECHO Please select: @ ECHO 1, DHCP auto assign 2, manually specify

The first is the setup of the network connection in Vitualbox. The default is for network address translation (NAT) to be modified to bridge the NIC, other default.Then is to go into the Ubuntu to modify the IP address, this is believed that everyone Baidu can find.sudo VI /etc/network/interfacesThen, modify the content inside, append the content:Auto Eth0Iface e

I have always encountered a problem recently. I have avoided it several times. Today I am making a decision to solve it. Problem: I want to fix the network adapter eth0 IP address, you can modify the successful/etc/sysconfig/network-scripts/ifcfg-eth0, restart the network adapter, eth0 cannot be started, when ifconfig, there is an eth1, but there is no ifcfg-eth1 file, so the

card device information shown in Figure 1[Root@master ~]# IP addr Show1:lo: Link/loopback 00:00:00:00:00:00 BRD 00:00:00:00:00:00inet 127.0.0.1/8 Scope host LoINET6:: 1/128 Scope HostValid_lft Forever Preferred_lft Forever2:eth0: Link/ether 52:54:00:a7:b7:56 BRD FF:FF:FF:FF:FF:FFinet 192.168.3.176/24 BRD 192.168.3.255 Scope Global eth0Inet6 FE80::5054:FF:FEA7:B756/64 Scope linkValid_lft Forever Preferred_lft Forever 2.

. configure the NIC in DHCP mode to edit the file/etc/network/interfaces: sudo vi/etc/network/interfaces and replace the eth0 row with the following line: # The primary network interface-use DHCP to find our addressauto eth0iface eth0 inet dhcp use The following command to make The network settings take effect: sudo/etc/init. d/networking restart can also directly enter the following command under the command line to obtain the

By default, docker uses the Bridge Mode to connect to the host machine through a bridge, while the internal IP address of the container gets unused IP addresses from the IP address segment of the bridge. This is inconvenient because the