hp 2524 switch

When configuring the HP switch, connect to the Console line of Cisco directly at startup, with the default baud rate. However, the command line does not display anything, so I thought the machine was broken and I changed several, the baud rate has also changed a lot. I also asked a senior network engineer, later, when I tested the brocade switch, a customer asked

This article is from the original blog of Lao Niu. Address: Ghost This article is from the original blog address of Lao Niu:Http://www.cnpublic.com/2009/08/hpnotebook-Ubuntu-wlan-led/Reprinted please note Today, I used my Hp notebook to wirelessly access the internet. I found a strange problem, that is, the wireless Nic switch at the Palm has been flashing after network connectivity, and it is red when it

Dual-host switch (NewStartHA, SKYbility, hacmp, hp unix dual-host), hpux dual-host 1. Suse linux (NewStartHA ):# Cli Cli: ~>Service-migrate Select service to migrate: Current service: 0) bill 1) gdb 2) cancel Select a service [0, 2]: Enter the command line prompt for replacement. 2. AIX (HACMP ): # Smit hacmp Then enter: Switch the resource from suibao01 to suib

1. Configure www.2cto.com for the HP Server1. Start> Control Panel> HP Network 2. Select two NICs and click Team3. Click Properties 4. Start with switch 5. Server Load balancer, select Auto www.2cto.com 2. Configure the H3C switch www.2cto.com[DeviceA] vlan 10[DeviceA-vlan10] port gigabitEthernet 1/0/1[DeviceA-vlan10]

Specific steps to execute the factory default reset on the switch are:1. Using a small, thin tool with blunt ends (such as a paper clip), simultaneously press both the Reset and Clear buttons on The front of the switch.2. Continue to press the Clear button while releasing the Reset button.3. When all three Mode LEDs (ACT, FDx, and SPD) begin to Blink, release the Clear button. The