I think my colleagues are very experienced in developing Ubuntu and want to learn about Linux. I have learned about this before, and finally chose centos, without using ubuntu. Of course, this is my personal reason. Re-partitioning the hard disk based on the original system, because the hard disk is divided into 80 GB to install centos. The dual system is finally installed. The only drawback is that there is no wireless NIC
Install wireless NIC Driver in acer AspireE1-472Gubuntu-12.04
I bought a relatively affordable notebook acer (acer) Aspire E1-472G, built-in linux operating system, because of work needs to replace the operating system with ubuntu12.04, however, it has been suffering from no wireless NIC Driver. The problem was finally
Wireless NIC Driver Installed in acer (acer) Aspire E1-472G ubuntu-12.04, ubuntu12.04
I bought a relatively affordable notebook acer (acer) Aspire E1-472G, built-in linux operating system, because of work needs to replace the operating system with ubuntu12.04, however, it has been suffering from no wireless NIC Driver.
The last time you update your system, you can only connect your wired network to a wireless network. I usually even wireless network, did not buy cable. So check the wireless driver related issues, found that the update system caused by the wireless network card
compiled. The following error occurs: KBUILD_NOPEDANTIC = 1.
Make-C/lib/modules/'uname-R'/build M = 'pwd' make [1]: Entering directory '/usr/src/kernels/2.6.38.2-9. fc15.x86 _ 64 'CC [M]
/Root/broadcom_bcm4313/src/wl/sys/wl_linux.o
/Root/broadcom_bcm4313/src/wl/sys/wl_linux.c: In function 'wl _ attach ':/root/broadcom_bcm4313/src/wl/sys/wl_linux.c: 485: 3: error: implicit declaration of function 'init _ MUTEX '[-Werror = implicit-function-declaration] C0: some warnings being treated as errors m
Recently I bought a high-power wireless network card with a chip of ralink3070, Which is used normally in Windows, but the speed in Ubuntu is always very unstable and cannot be accessed well. It is a problem with the driver, so you are prepared to reinstall a new driver. First download the latest driver http://www.rali
prevents the server from being enabled again at the next startup.
# rmmod bcma# echo "blacklist bcma" >> /etc/modprobe.d/blacklist.conf
In this case, some netizens suggested disabling all wireless modules in the system, including "b43" and "ssb". if they cannot be used after installation, try again. And add them to the blacklist.
To install the driver, check whether gcc and kernel-devel have been installed
APSAbove the kernel 3.0, it is easy to drive RT5730 with RT2800USBCode:sudo modprobe rt2800usbSudo-secho 148F 5370 >/sys/bus/usb/drivers/rt2800usb/new_idExitIfconfig, you can see Wlan0 's wireless interface.With HOSTAPD, enabling AP FunctionalityCode:[Email protected]:~/hostapd-0.7.3/hostapd$ cat hostapd.confInterface=wlan0driver=nl80211Logger_syslog=1logger_syslog_level=2Logger_stdout=1logger_stdout_level=2Debug=1Dump_file=/tmp/hostapd.dumpCtrl_inte
Install the Windows XP Wireless NIC Driver in linux-Linux Enterprise Application-Linux server application information. For more information, see the following. Probably useful to UBS
1. installation and configuration steps:
(1) extract:
Tar-zxvf ndiswrapper-1.52.tar.gz
(2) into the ndiswrapper-1.52:
Cd ndiswrapper-1.52
(3) Compile: make
// Before this operation, you must set up the compiling environment, t
[] Basic knowledge of Linux: TP-Link WN823N wireless network card (RTL8192EU chip) X86-64 and AARCH64 driver installation,
Purpose:
Enable embedded devices similar to Raspberry Pi's AARCH-64 architecture to connect to Ethernet over a USB wireless Nic;
The device has LAN interfaces. However, after the previous system firmware upgrade, the three internal network in
Tags: man EPO direct Linu network card open source Basics boot self-starting forObjective:An embedded device that resembles a Raspberry Pi AARCH-64 architecture can be connected to Ethernet via a USB wireless card;The device has a LAN interface, but in the previous system firmware upgrade, its internal three network interfaces can ping each other, but either interface cannot ping the external network interface, the problem is not resolved;In addition,
Solve the problem that "init_mutex" cannot be compiled because the wireless NIC driver is installed in Ubuntu. When I bought a wireless network card, I specifically found a network card with drivers for both windows, linux, and mac platforms. However, when the wireless network card is installed in Ubuntu11.04, the code
Install wireless network card driver for win7 in DELL lingyue n4030 notebook, n4030win7
I installed win7 32-bit Professional Edition. After installation, I found that the wireless network card could not be found. DELL linger n4030 comes with a wireless network card. The root cause of the problem is that the
Distribution: Ubuntu 12.04.5 lts
Kernel: 3.small-35-generic
Download the driver 5370 linux.rar from the Tenda official website, decompress the package, and get the token.
Decompress the package and enter the directory to modify OS/Linux/config. mk.
# Support wpa_supplicantHas_wpa_supplicant = y# Support native wpasupplicant for network magangerHas_native_wpa_supplicant_support = y(Change two n to Y)
An error occurred in sudo make. The value
Wireless Network Card. I am using netgearwgw.v2 of PCMCIA Interface. Ubuntu7.10 does not provide its driver by default, so we need to install the driver on our own. First, prepare the Windows driver for the wireless Nic, which must correspond to the NIC
After countless nights of struggle, I finally asked linux beginners to use wireless network cards in their laptops to access the Internet! Operating System: RHEL6.41. Do not trust the so-called tutorials on the Internet (like, I am sharing the tutorials). 2. Trust the official readme !!! Don't talk nonsense, start implementation: It is recommended that the entire process to switch to the root account, do not worry about permissions A, to Broadcom offi
win8.1 System How to update the wireless network card driver to solve the problem of offline access. win8.1 operating system users often encounter the network off the line, can not access the problem, do not know how to do? Online introduction said that as long as the Update network card driver can solve such problems, but the win8.1 system how to update the netw
Now most people like wireless internet, then how to use wireless network card, wireless network card driver How to install it? This tutorial provides a detailed introduction to the wireless network card driver installation method.
!!!
//////////////////////////////////////// //////////////////////////////////////// //////////////////////////////////////// //////////////////////////////////////// //////////////////////////////////////// ///////////////////////////////////
// Address: http://fosiao.com/node/18
I got a HP Compaq 8200 PC today, which has a i7 CPU with 16 GB ddr3 Ram. after Ubuntu 10.04 64bit is installed, no network connection is found. note: To get into bios,
After upgrading Ubuntu11.04, I still cannot find the wireless network and cannot work with the built-in driver. I have tried many methods to compile wl by myself, but still failed. Final Solution Adda "contrib" componentto/etc/apt/sources. list, forexample: # DebianSqueeze/6.0 debhtt
After upgrading Ubuntu 11.04, I still cannot find the wireless network and canno
The content source of this page is from Internet, which doesn't represent Alibaba Cloud's opinion;
products and services mentioned on that page don't have any relationship with Alibaba Cloud. If the
content of the page makes you feel confusing, please write us an email, we will handle the problem
within 5 days after receiving your email.
If you find any instances of plagiarism from the community, please send an email to:
info-contact@alibabacloud.com
and provide relevant evidence. A staff member will contact you within 5 working days.