internet nslookup

Recently, my colleague reported that during the NSLookup test on the Intranet, I found that when I used the Intranet DNS server 192.168.1.1 for resolution, the DNS server responded very quickly and did not Any errors. However, when the DMZ server 51.

NSLookup -Qt = mx Email server IP address or domain name The domain name or IP address of the specified DNS server. Usage:Query IP addresses The simplest use of NSLookup is to query the IP address corresponding to the domain name, including the

Grammar nslookup [-subcommand ...] [{computertofind| [-server]}] Parameters -subcommand ...Specifies one or more nslookup subcommand as command-line options.ComputerToFindIf no other server is specified, the current default DNS name server is

I. Host directiveFormat: Host [-A] FQDN [server]HOST-L domain [Server]Options:-A: Represents a list of all relevant information about the host, including IP, TTL, and error-removing messages, etc.-L: If the next domain setting allows Allow-transfer,

The nslookup command is used to query DNS records to see if domain name resolution is normal and to diagnose network problems in the presence of a network failure. The use of Nslookup is relatively simple, mainly the following several uses. 1.

Nslookup (name server lookup): a tool used to query Internet domain name information or diagnose DNS server problems. Let's take a look at the installation method. CentOS 6.xis installed in the new VPS, and the nslookup command is not installed by

Description: The NSLookup command is a program that queries the Internet Domain Name Service. The NSLookup command has two modes: Interactive and non-interactive. Interactive Mode allows users to query different types of hosts and domain names

NSLookup command usage gl dq/& X 1. query a record h sa l'} o C:/> NSLookup www.cdnunion.com = (Ka 3! * ** Can't find server name for address 192.168.2.1: non-existent domain S & wfwj * ** Default servers are not available SN/nfdaq Server:

1. install the software packages dig and nslookup. Centos: # yuminstallbind-utilsDebian: # apt-getupdate # apt-getinstalldnsutils set the dns server IP address in/etc/resolv. conf before querying. II. usage 1. install the software packageInstall

1. Network Tools: ifconfig, ping, netstate, Redhat command and graphical settings of ip, finger, nslookup, ifconfignetstateZookeeper 1 ip ad view Nic ID 2. View Nic information in ifconfig 3. Disable the NIC 4. Start the NIC 5. configure a