ip sla configuration

The IP SLA is an abbreviation for the Internet Protocol Service-level Agreement, which means the Internet Protocol Service level agreement. IP SLAs are mainly used in the following situations:1. Static route Next-hop detection.2.HSRP out interface detection.The 3.PBR policy routes the next hop detection.650) this.width=650; "src=" http://s3.51cto.com/wyfs02/M00/5

{PRIMARY:NODE0} [Edit Services][Email protected]# ShowRPM {Probe Probe-2nd-line {Test 2nd-isp {Target address 11.22.33.44; //Probe target address, probe type default is Icmp-pingProbe-count 6; How many times, 6 times?Probe-interval 10; The detection interval is 10 seconds each time.Test-interval 15; 6 times a cycle, how many seconds each cycle interval, 15 seconds. It means that there is No 10 seconds to send a ping, 6 times, 6 times, and so on for 15 seconds in a new round of detection.History

{PRIMARY:NODE0} [Edit Services][Email protected]# ShowRPM {Probe Probe-2nd-line {Test 2nd-isp {Target address 11.22.33.44; //Probe target address, probe type default is Icmp-pingProbe-count 6; How many times, 6 times?Probe-interval 10; The detection interval is 10 seconds each time.Test-interval 15; 6 times a cycle, how many seconds each cycle interval, 15 seconds. It means that there is No 10 seconds to send a ping, 6 times, 6 times, and so on for 15 seconds in a new round of detection.History

(Inside, Backup) static61.1.1.4ObjectnetworkOutside-to-backupNat (Inside, Outside) static61.1.1.4ObjectnetworkBackup-to-outsideNat (Inside, Backup) static202.100.1.4-- Two NAT entries are configured for each line to ensure that both static NAT entries can be accessed when an ISP line fails.④ Firewall Policy Configuration: Class-mapALL_IPMatchanyPolicy-mapglobal_policyClassinspection_defaultInspecticmpClassALL_IPSetconnectiondecrement-ttlService-polic

Ubuntu 15.10 sets static ip Address Allocation fixed ip Address Settings dns settings gateway command line configuration ip fixed ip address does not take effect what to do, ubuntu15.10 Files to be used: Configure Interface Information /Etc/network/interfaces

Troubleshoot CentOS7 IP configuration and network problems, and centos7 ip configurationNote content: CentOS7 configuration IP address and network troubleshooting Note Date: 2017.8.1 CentOS7 configuration

Now some hosts have multiple NICs how to configure each NIC with a different IP address for the same network segment:1. Use Ifconfig to see how many network cards are available: I'm hosts are Nic:eth0 and Eth8.An IP has been configured on the eth0 now I need to configure the IP address on the ETH82. First check that the NIC is well connected: for example, if the

Linux CentOS configuration IP, linuxcentos configuration ip Demo EnvironmentVMware8 + Linux CentOS 6.2x32Set IP, website, DNS 1. Modify and edit Nic configurations # Vi/etc/sysconfig/network-scripts/ifcfg-eth0 DEVICE = "eth0"ONBOOT = yesHWADDR = 00: 0C: 29: 5D: 18: EETYPE

Tags: IP source GuardNetwork topology structure:Scenario Description:Core layer: Each VLAN interface gateway is at the core layerAggregation layer: Two stacks, port-channel to the core layer, Port-channel Xia Lian to the access layer, do not run dynamic routingAccess layer: Two port Port-channel, link to two aggregation switches respectivelyObjective:Prevent internal enterprise network from accessing DHCP server through DHCP snooping;Prevent internal

0.0.0.0 GW 172.16.1.106Check out these three newly createddestinationgateway genmaskflagsmetric RefUseIface192.168.1.110172.16.1.106 255.255.255.255UGH00 0eth0192.168.1.0172.16.1.106 255.255.255.0UG00 0eth00.0.0.0 172.16.1.1060.0.0.0ug 00 0eth0 3. Delete a route# route Del-host 192.168.1.110# Route del-net 192.168.1.0/24Third, DNS configurationThe content can only be modified by configuration file:/etc/resolv.conf; Generated by/sbin/dhclient-scriptse

a long time, it is best to save the alias information, there are two general methods, as follows:1. Fill in the/etc/rc.local file with the command to add IP aliasGoing to be all like this ifconfig eth0:0 192.168.6.100 netmask 255.255.255.0 up of the command line to fill in the Rc.local file, rc.local file is the role of Linux boot Automatic command, the detailed use of G or B, here do not specify.This method is the most convenient, but not very relia

0.0.0.0 GW 172.16.1.106Check out these three newly createddestinationgateway genmaskflagsmetric RefUseIface192.168.1.110172.16.1.106 255.255.255.255UGH00 0eth0192.168.1.0172.16.1.106 255.255.255.0UG00 0eth00.0.0.0 172.16.1.1060.0.0.0ug 00 0eth0 3. Delete a route# route Del-host 192.168.1.110# Route del-net 192.168.1.0/24Third, DNS configurationThe content can only be modified by configuration file:/etc/resolv.conf; Generated by/sbin/dhclient-scriptse

165.91.122.67; Save it for a second. 3. Add the following configuration to the Nginx configuration file nginx.conf , which can be placed in HTTP, server, location, limit_except statement block, and need to pay attention to relative path, In this case, nginx.conf,blocksip.conf is in the same directory. Copy Code code as follows: Include blockip.conf; 4. Restart the Nginx ser

Node2-priv.localdomain Node2-vip Virtual IP 172.16.0.194 Eth0:1 Node2-priv.localdomain Node2-priv Private IP 192.168.94.12 Eth1 Scan-cluster.localdomain Scan-cluster SCAN IP 172.16.0.203 Eth0 After IP assignm

I. Configuring a static IP for a wireless networkEdit the/etc/network/interfaces file as follows:192.168. 1.120 255.255. 255.0 192.168. 1.1 # (depending on the situation) DNS 8.8. 8.8 8.8.4.4 # (fill in the details)4. Restart the Network Service command as follows:#/etc/init.d/networking restart5. Set up extranet access DNS editing/etc/resolv.conf as follows:8.8. 8.8 8.8. 4.4This configuration disappears

Sometimes we want the IP address of the Ubuntu14.04 to be static IP address, so that the IP address in Ubuntu is not changed, this will be convenient in the embedded device and host Ubuntu to use the network port for debugging.Static IP address configuration method: In the/e

Linux System Dynamics IP acquisition and Static of addresses IP configuration of the addressToday in Linux The system has done the following experiments in this experiment encountered in the knowledge points and the experimental process is as follows#- 1 . Broadcast protocol options [Bcast] broadcast specify IP