multiport ethernet card

In Solaris, how to configure FCHBA to an Ethernet card, IPFC, can easily set an FCHBA card to an Ethernet card, which is of great significance in reality. In some work sites, if you need to copy a large amount of data through the network, it is often found that the speed of

Article Title: installation and configuration of the Ethernet Card in Linux. Linux is a technology channel of the IT lab in China. Includes basic categories such as desktop applications, Linux system management, kernel research, embedded systems, and open source. The Linux operating system is favored by more and more people of insight with its unique openness, stability, and efficiency. As IT giants announc

Ethernet card settings for the Solaris 10 Operating System (1)-Driver Installation Preface: The setting of the Ethernet Card (NIC) in the Solaris operating system is a common topic. There are countless materials available on the Internet. But for friends who have just been familiar with Solaris, what is most needed is

Introduction With the gradual improvement of Ethernet stability, anti-interference and bandwidth problems, Ethernet is entering the industrial control field on a large scale. It is used in industrial process control, communication, spacecraft and navigation systems, and has extremely high requirements on the high speed of reliability and fault response. Currently, redundancy design has been widely used as

Now many enterprises have installed Linux and may encounter installation and configuration problems of the Linux Ethernet card. Here we will introduce the installation and configuration of the Linux Ethernet Card, the following uses the Crystal CS8920 ethernet

In Solaris, how to configure the fc hba to an Ethernet Card IPFC can easily set a fc hba to an Ethernet card, which is of great significance. In some work sites, if you need to copy a large amount of data through the network, you will often find that the speed of the Gigabit Nic is insufficient, and network aggregation

Let's talk about the installation process of the Ethernet card driver on ASUSN6 series computers under Fedora18. The computer is ASUSN6 series, and the ethernet card model is AtherosAR8161/8165. The driver for Linux is not found on the official website of this Nic. Search for the installation of the NIC driver on the I

The hardware components of the Ethernet Card are MAC/PHY/transformer/EEPROM. On our platform, Mac is generally integrated into the master. The PHY and the transformer are separated. (Because PHY simulates differential signals externally and integrates a large number of analog hardware, Mac is a typical full digital device. Chip area and analog/digital hybrid architecture are the reasons why Mac is first int

To use the de2-115 on hand to write a driver about Ethernet communication, after so many days of experimental debugging finally have some knowledge.1, I observed the network card to send data and receive data, I found that I send data from a network card on the FPGA, and then another network card to receive data, the r

To the Duplex of an Ethernet card, we can use the ethtool -a Linux utility for Displaying or changing E Thernet card settings.1. Install EthtoolYou can install Ethtool by typing one of the following commands, depending upon your Linux distribution.Install Ethtool in Fedora, CentOS, RHEL etc.:# yum Install EthtoolInstall Ethtool in Ubuntu, Debian etc.:# sudo apt-g