netgear switch port mirroring

One, single port mirror 23 port mirrored to 24 portObserve-port 1 Interface gigabitethernet 0/0/24 (set observation port. 24)Interface G0/0/23Port-mirroring to Observe-port 1 {both | inbound | outbound}(All | In-direction | Outwar

Common brand Switch Port Mirroring) Configuration Port Mirroring ing) allows you to copy all traffic from a specific Port to an Image Port. > If your vswitch provides a

, the three products only support mirroring inbound port traffic. Although the outbount parameter exists, it cannot be configured.The image group name is 1, the monitoring port is ethernet4/0/2, and the inbound traffic on the port ethernet4/0/1 is mirrored.[Switcha] grouping ing-group 1 inbound ethernet4/0/1 mirrored-t

1 Catalyst 2550/3550 support for 2 group monitor sessions Switch (config) #monitor session 1 Destination Interface F0/4 (1 is the session Id,id range for 1-2//defines port source mirroring, which is the port traffic that the administrator wants to see Switch (config) #moni

In order to manage a network, the network grasping the packet Analyzer is essential, but now is no longer the hub era, grab bag is not so easy, but there is always a way to mirror the port, the other port data copy to the port you specify, so you can grab the bag. Today is not about grabbing bags, It is mainly about how to configure the Cisco

I. Port Mirroring concept: Port Mirror is used for network performance monitoring. It can be understood as follows: Establish an image relationship between port A and port B. In this way, data transmitted through port A will be co

[SwitchA] mirrored-to ip-group 101 interface e0/8 2-layer stream-Based Image 〗◆ Define an ACL [SwitchA] acl num 200◆ Define a packet from E0/1 to all other ports [SwitchA] rule 0 permit ingress interface Ethernet0/1 (egress interface any)◆ Define a data packet from all other ports to E0/1 [SwitchA] rule 1 permit (ingress interface any) egress interface Ethernet0/1◆ Mirror data packets that match the preceding ACL to E0/8 [SwitchA] mirrored-to link-group 200 interface e0/8 5516]Allows you to con

In the switched Ethernet environment, the communication between the two workstations is not heard by the third party. In some cases, we may need to do such listening, such as protocol analysis, traffic analysis, intrusion detection. For this we can set the span (switchedportanalyzer Switch Port Analyzer) feature of the Cisco switch, or the early "