netgear switch uplink port

Note: Each interface supports only one policy, and one policy can be used for multiple interfaces. Therefore, the download rate limit for the network segment under the port should be defined in the same policy 1. Start QoS on the switch Switch (config) #mls QoS//Start QoS on the switch 2. Define Access Control List

allows packets sent by default VLAN without tags. 1.4 Fabric port Mode The Fabric port is the port between units in IRF. It is only used for interconnection between units and cannot connect users. 2 Application of Hybrid port Mode By introducing the various link port modes

I. Port Mirroring concept: Port Mirror is used for network performance monitoring. It can be understood as follows: Establish an image relationship between port A and port B. In this way, data transmitted through port A will be copied to

uplink port load. Further analysis showed that an RSPAN process was enabled on two central Ethernet switches, and the traffic on the RSPANVLAN was large, reaching 300 MB. Because the Pruning function is not enabled in The VTP domain, the traffic of this RSPANVLAN appears on all trunks, resulting in blocking. After the RSPANVLAN is trimmed from these trunks, the network returns to normal. The emergence of t

-detect action block Port-isolate enable NTDP enable NDP Enable#interface ethernet0/0 /21 Port default VLAN 964 Loopback-detect enable Loopback-detect action block Port-isolate enable NTDP enable NDP enable#i Nterface ETHERNET0/0/22 port default VLAN 964 Loopback-detect enable Loopback-detect action block