openwrt network config

This is a translation of the OpenWrt network interface, source address: http://wiki.openwrt.org/doc/networking/network.interfacesNetwork interface types: physical and virtual network interfacesThe physical network interface is what we often see ETH0,RADIO0,WLAN9 and so on, which represent an actual

For some reason, the following description will be more general, can be understood is the same with me, can not understand a smile.Guilin, a university and ISP custom agreement to enable students to use school equipment and some of the ISP provided by the network outside the Internet, but school students must use a certain software dialing (the software sent a specific UDP packet to a server in the campus, after the certification can be used in the ca

WDS wireless network expansion using OpenWrt on WHR-G300N V2Click OpenWrt The hardware of Buffalo WHR-G300N V2 is the same as that of the WHR-G301, so you can use the firmware for it directly. If you haven't flushed OpenWrt in Buffalo WHR-G300N V2 or updated to 15.05, you can follow the procedure below: Go to

after the interface is configured. Join as simple as the following: Config Route fooOption interface LANOption Target 1.1.1.0Option Netmask 255.255.255.0Option Gateway 192.168.1.1 The name in the route segment is optional, and the Interface,target and gateway options are mandatory. Not using the netmask option will cause the route to be set to the host route. The name for the route sections is optional, the interface, Targetand gateway options are ma

When the application is successfully developed as a system service, it is really a good thing to start or stop the service freely at the console restart. But the problem is, if we can not only use the application in the router console, we can also use the OPENWRT Web management interface to start or stop the application and get the status of the application (such as to get the campus network balance and cur

Article title: Fedora network configuration tool system-config-network introduction. Linux is a technology channel of the IT lab in China. Including desktop applications, Linux system management, kernel research, embedded systems and open source, etc. This article mainly introduces the network configuration tool system

the Ifcfg-ethx file configuration is still in effect after the reboot, which is very useful in network management, and now I ifcfg-ethx the IPV4 network configuration method for a simple description of the file.Open commands and information according to the file Ifcfg-eth0 as follows:[[Email protected] ~]# Vi/etc/sysconfig/network-scripts/ifcfg-eth0 Device=eth0#

　　　　　　Modify UUID1. Delete the information for the line that contains the MAC address in the/etc/sysconfig/network-scripts/ifcfg-eth0 configuration file2. Remove the NIC and MAC address bindings file: Rm-rf/etc/udev/rules.d/70-persistent-net.rules3. Restart your computer　　　　Host name FileFile address:/etc/sysconfig/network, File contentsNetworking=yes Network Ser

Create | network If you find that easy Config does not start, and the original network service is working properly, you can create, modify, and delete network services in the following ways. 1 Create (Add a new network service) Under your Oracle installation directory. \orac

For Debian Linux# Dhcpauto eth0iface eth0 inet dhcp# staticauto eth0iface eth0 inet staticaddress 10.16.3.99netmask 255.255.255.0network 1 0.16.3.0broadcast 10.16.3.255gateway 10.16.3.1/etc/init.d/networking RestartFor Redhat LinuxTemporarily modify the NIC Ipifconfig eth0 172..16.0.5/16 up Add Gateway route add default GW 172.16.0.111 temporarily modify the defaults dnsvim/etc/resolv.confvim/etc/ sysconfig/network-scripts/ifcfg-eth1device=eth1hwaddr=